ERC carbamin 5100 Super Konzentrat

Ensure supply of fresh air.

When in contact with the skin, clean with soap and water.

Remove contact lenses. Rinse eye thoroughly under running water keeping eyelids wide open and protecting the unaffected eye (at least 10 to 15 minutes). Get immediate ophthalmic treatment.

Rinse the mouth thoroughly with water. Call a doctor immediately. Never give anything by mouth to an unconscious person. If individual is drowsy or unconscious, place in recovery position (on left side, with head down).

Water spray jet; Foam; Extinguishing powder; Carbon dioxide

High power water jet

In the event of fire, the following can be released: Carbon dioxide (CO2); Carbon monoxide (CO)

Cool endangered containers with water spray jet.

For non-emergency personnel: Refer to protective measures listed in sections 7 and 8. Ensure adequate ventilation. Avoid contact with skin, eyes and clothing.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

Take up with absorbent material (e.g., sand, kieselguhr, universal binder). When collected, handle material as described under the section heading "Disposal considerations".

Materials: absorbent material (e.g., sand, kieselguhr, universal binder)

Provide good ventilation at the work area (local exhaust ventilation, if necessary). Risks inherent to handling the product must be minimised by applying the appropriate protective and preventive measures. Working processes should - so far as possible, according to the state of the art - be designed to rule out bodily contact or the release of hazardous substances.

Keep container tightly closed in a cool, well-ventilated place.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Avoid contact with eyes and skin. Remove soiled or soaked clothing immediately. Wash hands before breaks and after work. Provide eye wash fountain in work area.

Keep away from sources of heat and ignition.

No data available.

Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of risk of skin contact with the product. Before use, the protective gloves should be tested in any case for its specific workstation suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves. - Appropriate Material: PVC - Material thickness: min. 0.8 mm

Tightly fitting safety glasses (EN 166).

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified.

Normal chemical work clothing.

No data available.

Stable under recommended storage and handling conditions (See section 7).

No data available.

Dangerous reactions are not to be expected when handling product according to its intended use.

None, if handled according to intended use.

Oxidizing agents

No data available.

No data available.

No data available.

No data available.