Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- NovoTec A
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Granulation additive for fertilizers.
Manufacturers & Suppliers
HOLLAND NOVOCHEM B.V.
manufacturer
Papiermolen 5, 3994 DJ Houten, The Netherlands
+31 (0)30 - 602 15 33
http://www.novochemgroup.com
Emergency Contacts
HOLLAND NOVOCHEM B.V.
+31 (0)30 - 602 15 33
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS07
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
Surface-active components in water.
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| surface-active substances | --- | 25 - 50% | Yes |
The product does not contain substances mentioned on the SVHC-list (Annex XIV of REACH). For the wording of the listed hazard phrases refer to section 16.
Notes
The product does not contain substances mentioned on the SVHC-list (Annex XIV of REACH).
First Aid Measures
Emergency procedures for chemical exposure incidents
Remove to fresh air.
Immediately wash with water and soap and rinse thoroughly.
Rinse opened eye for at least 15 minutes under running water. If symptoms persist, consult a doctor.
Rinse out mouth and then drink plenty of water.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
CO2, powder or water spray. Foam
Water with full jet.
In case of fire, the following can be released: Carbon monoxide and carbon dioxide (COx), Sulphur oxides (SOx)
Firefighter Protection
Wear self-contained respiratory protective device.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Clean up spillages promptly as these may make surfaces slippery.
Do not allow to enter sewers/ surface or ground water.
Absorb with appropriate liquid-binding material. Collect for recovery or disposal in suitable receptacles. Flush residues with plenty of water and drain into a biological water purification plant.
Materials: sand, diatomite, acid binders, universal binders, sawdust
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
No special measures required.
Between +15 and +40 °C.
No special measures required.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Protective gloves. The determined penetration times according to EN 374 part III are not performed under practical conditions. Therefore a maximum wearing time, which corresponds to 50% of the penetration time, is recommended.
Safety glasses
Not required.
Protective work clothing.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
No decomposition if used according to specifications.
No further relevant information available.
Reacts with oxidizing agents
No further relevant information available.
No further relevant information available.
In case of fire or overheating the following products can be released: Carbon monoxide and carbon dioxide (COx) Sulphur oxides (SOx)
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Disposal according to local regulations.
Disposal according to local regulations.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- Not applicable
- Shipping Name
- Not applicable
- Transport Class
- Not applicable
- Packing Group
- Not applicable
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The product is classified and labelled according to the CLP regulation.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for NovoTec A?
The signal word is warning.
What is the physical form of NovoTec A?
NovoTec A is a liquid appearing as liquid with amber coloured color. It has characteristic odor.
What is NovoTec A used for?
Granulation additive for fertilizers.
What are the hazard statements for NovoTec A?
This substance has 1 hazard statement:
- H319: Causes serious eye irritation.
What is the melting point of NovoTec A?
The melting point is undetermined and the boiling point is 100 °C.