N,N-Dimethylformamide PEPTIPURE® ≥99,8 % for peptide synthesis

Provide fresh air. In all cases of doubt, or when symptoms persist, seek medical advice.

Rinse skin with water/shower.

Irrigate copiously with clean, fresh water for at least 10 minutes, holding the eyelids apart. In case of eye irritation consult an ophthalmologist.

Symptoms: eye irritation

In case of accident or unwellness, seek medical advice immediately (show directions for use or safety data sheet if possible).

Co-ordinate fire-fighting measures to the fire surroundings water spray, foam, dry extinguishing powder, carbon dioxide (CO₂)

water jet

Combustible. Vapours are heavier than air, spread along floors and form explosive mixtures with air. Vapours can form explosive mixtures with air.

Fight fire with normal precautions from a reasonable distance.

Wearing of suitable protective equipment (including personal protective equipment referred to under Section 8 of the safety data sheet) to prevent any contamination of skin, eyes and personal clothing. Avoid contact with skin, eyes and clothes. Do not breathe vapour/spray. Avoidance of ignition sources.

Keep away from drains, surface and ground water. Explosive properties.

Absorb with liquid-binding material

Materials: liquid-binding material (sand, diatomaceous earth, acid- or universal binding agents)

Provision of sufficient ventilation. Measures to prevent fire as well as aerosol and dust generation. Keep away from sources of ignition - No smoking. Take precautionary measures against static discharge.

Keep container tightly closed. Recommended storage temperature: 15 – 25 °C.

Wash hands before breaks and after work. Keep away from food, drink and animal feedingstuffs. When using do not smoke.

Measures to prevent fire as well as aerosol and dust generation. Keep away from sources of ignition - No smoking. Take precautionary measures against static discharge.

Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves. The times are approximate values from measurements at 22 °C and permanent contact. Increased temperatures due to heated substances, body heat etc. and a reduction of the effective layer thickness by stretching can lead to a considerable reduction of the breakthrough time. If in doubt, contact manufacturer. At an approx. 1.5 times larger / smaller layer thickness, the respective breakthrough time is doubled / halved. The data apply only to the pure substance. When transferred to substance mixtures, they may only be considered as a guide. Type of material: Butyl caoutchouc (butyl rubber). Material thickness: ≥0,5 mm. Breakthrough times of the glove material: >480 minutes (permeation: level 6).

Use safety goggle with side protection.

Respiratory protection necessary at: Aerosol or mist formation. P2 (filters at least 94 % of airborne particles, colour code: White). Type: A (against organic gases and vapours with a boiling point of > 65 °C, colour code: Brown). Observe the wear time limits according GefStoffV in combination with the rules for using respiratory protection apparatus (BGR 190).

Keep away from drains, surface and ground water.

The material is stable under normal ambient and anticipated storage and handling conditions of temperature and pressure.

Risk of ignition. In case of warming: Vapours can form explosive mixtures with air.

Violent reaction with: Strong oxidiser

Keep away from heat. Decomposition takes place from temperatures above: >350 °C.

There is no additional information.

Hazardous combustion products: see section 5. Release of: Formaldehyde. Ammonia (NH3).

Provisions for dangerous goods (ADR) should be complied within the premises.