Alfa Neutra

Supply fresh air; consult doctor in case of complaints.

Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

Rinse cautiously with water for 20 minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

Symptoms: Can cause permanent eye damage.

Rinse out mouth and then drink plenty of water. If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label.

Water, Foam, Fire-extinguishing powder

Not applicable.

Formation of toxic gases is possible during heating or in case of fire.

Wear protective equipment. Keep unprotected persons away. Do not breathe vapour. Do not get in eyes, on skin, or on clothing.

Dilute with plenty of water. Send for recovery or disposal in suitable receptacles. Do not allow to enter sewers/ surface or ground water.

Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Use neutralizing agent.

Materials: sand, diatomite, acid binders, universal binders, sawdust

When diluting, always stir the product into standing water, not water to product. Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. When using do not eat, drink or smoke. Avoid contact with skin and eyes. Ensure that washing facilities are available at the work place.

Store in a dry place. Store only in the original receptacle. Keep receptacle tightly sealed.

When using do not eat, drink or smoke. Ensure that washing facilities are available at the work place.

No special measures required.

No further data; see item 7. Use only in well-ventilated areas.

Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: Natural rubber, NR, Chloroprene rubber, CR. Recommended thickness of the material: ≥ 1 mm. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Tightly sealed goggles

In case of insufficient ventilation, wear suitable respiratory equipment. Use suitable respiratory protective device only when aerosol or mist is formed. Filter P2. In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use respiratory protective device that is independent of circulating air.

Use protective suit. (EN 1406)

Do not allow to enter sewers/ surface or ground water.

No decomposition if used and stored according to specifications.

Reacts with acids. Forms heat.

Heating occurs when water is added. Reacts with acids. Reacts with certain metals.

No further relevant information available.

Refer to section 10.3 above.

No dangerous decomposition products known.

Small amounts may be diluted with plenty of water and washed away. Dispose of bigger amounts in accordance with Local Authority requirements.

Must not be disposed of together with household garbage.