Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- PERIODIC ACID, 1 % SOLUTION
- Product Code
- PK1-OT-X**
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
For use with special staining kits.
Uses advised against
Only the identified uses are advised. The product is intended for use only as an in vitro diagnostic medical device, registered at the Agency for Medicinal Products and Medical Devices and there is no reason to use it for other purposes
Manufacturers & Suppliers
BioGnost Ltd.
manufacturer
Medjugorska 59, Zagreb
+385 1 2409997
Emergency Contacts
National Protection and Rescue Directorate
112
Medical information
+385 1 2348 342
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
GHS Pictograms
Manage your Safety Data Sheets
Organize and access chemical safety data with ease
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
The data for this section has not been processed yet.
First Aid Measures
Emergency procedures for chemical exposure incidents
Carry the afflicted person out of the contaminated area into a well-ventilated area or out for fresh air. If breathing becomes erratic or it stops, immediately apply artificial respiration (other than mouth-to-mouth) and contact a physician.
Symptoms: coughing, sneezing, headache and nausea
Remove contaminated clothing. Immediately wash with plenty of water and soap. Seek medical assistance if the symptoms of irritation remain.
Symptoms: Slight irritation. After short exposure, resorption effects are not likely. Long-term exposure may cause drying, cracking and tingling sensation of skin.
Rinse out with plenty of water with the eyelid held wide open using clean fingers. If the symptoms remain, immediately call a physician.
Symptoms: Direct eye contact may cause slight to moderate irritation, lacrimation and burning sensation.
Do not induce vomiting. Make the afflicted person drink a glass of water. If spontaneous vomiting occurs, wash the mouth with water, then make the person drink 100-200 ml of water and seek medical attention.
Symptoms: Swallowing may cause irritation of mucosa, tingling sensation in the mouth, burning sensation; higher levels of concentration may cause nausea, abdominal pain and vomiting. In case of vomiting, aspiration causes coughing, difficult breathing. Higher levels of concentration may cause suffocation.
Medical Treatment
Treat symptomatically.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Small fire - water spray, dry powder, CO₂. Large fire - water spray or alcohol-resistant foam
water jet
Cool closed containers exposed to fire with water spray or vapor.
Firefighter Protection
Use a self-contained open-circuit compressed air breathing apparatus and fireproof clothing.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Mark the area using proper signs.
In case of large spillage contact National Protection and Rescue Directorate (NPRD) on 112.
Do not dispose of in sewage, drainage system and waterways.
Where possible, the substance can be absorbed by using inflammable material (sand, diatomaceous earth, vermiculite). Place the waste material in tightly closed impermeable containers. Store the substance in well ventilated storage rooms until disposal. Submit for disposal to the legal persons authorized by the Ministry of Environmental and Nature Protection. After disposal of the products, wash the area and and involved materials with water.
Materials: sand, diatomaceous earth, vermiculite
Related Products
Similar products with comparable safety profiles
Periodic acid 0.5 percent
---
periodic acid
---
TRICHLOROACETIC ACID, SOLUTION
---
PHOSPHORIC ACID 75%
---
Hydrochloric acid, 1.0N Standardized Solution
UFI: 6ACQ-4W9Y-GU10-65DG
Peracetic Acid Solution, ca. 39% in Acetic Acid
---
3-HYDROXYPROPIONIC ACID 30% SOLUTION IN WATER
---
SUBERIC ACID (2,2,7,7-D4, 98%)
CAS: 19031-57-3
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Keep away from sources of heat and ignition. Do not smoke.
Keep in tightly closed and upright set containers in a well ventilated storage rooms, and away from sources of heat, sunlight, and other incompatible substances.
Do not eat, drink or smoke in the workspace. Thoroughly wash hands after work and before eating.
Keep away from sources of heat and ignition. Do not smoke.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Use the product in well ventilated rooms. Organization of work in order to reduce other worker's influence during work process. Secure proper workspace ventilation in order to keep concentration levels in air below permitted levels. Structural measures to prevent exposure: No information available.
Protective gloves must be according to the EU Directive 2016/425/EEC and standard EN 374. Gloves material: nitrile rubber, Gloves thickness: ≥0.50 mm, Break through time: >480 min
Safety glasses that stick to face (preventing splashing) (EN 166) or visor.
Protective full face mask (EN 136) or half mask (EN 140) equipped with a filter for organic vapors, type "A" (boiling point >65°C) according to EN 14387) used when concentration levels exceed GVI.
Wear antistatic clothing made of natural fibers (such as cotton) with long sleeves (EN 13034), and shoes that cover the entire foot (EN 10335).
See Section 6. Use modern equipment. Adapt the work process to the required working conditions of the workplace.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
The product is chemically stable under standard ambient conditions of storing and using.
See subsections 10.3 through 10.5.
With strong oxidants, sodium-hydroxide, sulfuric acid, aluminum.
Sources of heat, sparks, and ignition.
Aluminum.
No information available.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for PERIODIC ACID, 1 % SOLUTION?
The signal word is no signal word.
What is the physical form of PERIODIC ACID, 1 % SOLUTION?
PERIODIC ACID, 1 % SOLUTION is a liquid with colourless color. It has no odor odor.
What is the solubility of PERIODIC ACID, 1 % SOLUTION?
Soluble in water (20 °C)
What is PERIODIC ACID, 1 % SOLUTION used for?
For use with special staining kits.