edding permanent ink (red) contained in: edding 300, edding 330

Remove affected person from the immediate area. Ensure supply of fresh air.

Wash off immediately with soap and water. Do NOT use solvents or thinners.

Remove contact lenses. Rinse eye thoroughly under running water keeping eyelids wide open and protecting the unaffected eye (at least 10 to 15 minutes). Seek medical assistance.

Rinse mouth thoroughly with water. Call a doctor immediately. Never give anything by mouth to an unconscious person.

Alcohol-resistant foam; Extinguishing powder; Carbon dioxide; Water spray jet

High power water jet

In the event of fire, the following can be released: Carbon dioxide (CO2); Carbon monoxide (CO)

Cool endangered containers with water spray jet. Suppress gases/vapours/mists with water spray jet.

Refer to protective measures listed in sections 7 and 8. Avoid contact with skin, eyes and clothing. Ensure adequate ventilation. Keep away sources of ignition.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

Take up with absorbent material. Send in suitable containers for recovery or disposal.

Materials: sand, kieselguhr, universal binder

Provide good ventilation at the work area (local exhaust ventilation, if necessary). If workplace exposure limits are exceeded, respiratory protection approved for this particular job must be worn. Product inherent handling risks must be minimised taking the appropriate measures for protection and preventive actions. The working process should be designed to rule out the release of hazardous substances or skin contact as far it is possible by the state of the art.

Keep container tightly closed and dry in a cool, well-ventilated place. Protect from heat and direct sunlight. Containers which are opened must be carefully closed and kept upright to prevent leakage. Always keep in containers of same material as the original one.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Avoid contact with eyes and skin. Remove soiled or soaked clothing immediately. Do not inhale vapours. Clean skin thoroughly after work; apply skin cream.

Take precautionary measures against static charges. Keep away from sources of heat and ignition.

No data available.

Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of risk of skin contact with the product. Before use, the protective gloves should be tested in any case for its specific workstation suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves. Appropriate Material butyl rubber, Material thickness 0.5 mm, Breakthrough time > 240 min

Safety glasses with side protection shield (EN 166)

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified.

Normal chemical work clothing.

No data available.

Stable under recommended storage and handling conditions (See section 7).

No data available.

No data available.

No data available.

Acids; Alkalis; Oxidizing agents

No hazardous decomposition products known.