BIOHYDRAN TMP 46

Move to fresh air.

Symptoms: Inhalation of vapors in high concentration may cause irritation of respiratory system.

Remove contaminated clothing and shoes. Wash skin with soap and water. Wash contaminated clothing before reuse. High pressure jets may cause skin damage. In this case, the casualty should be sent immediately to hospital.

Symptoms: Not classified. High pressure injection of the products under the skin may have very serious consequences even though no symptom or injury may be apparent.

Rinse thoroughly with plenty of water, also under the eyelids.

Symptoms: Not classified.

Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Call a physician or Poison Control Center immediately.

Symptoms: Not classified. Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhea.

Carbon dioxide (CO₂). ABC powder. Foam. Water spray or fog.

Do not use a solid water stream as it may scatter and spread fire.

Incomplete combustion and thermolysis may produce gases of varying toxicity such as carbon monoxide, carbon dioxide, various hydrocarbons, aldehydes and soot. These may be highly dangerous if inhaled in confined spaces or at high concentration.

Cool containers / tanks with water spray.

Do not touch or walk through spilled material. Contaminated surfaces will be extremely slippery.

Do not allow material to contaminate ground water system. Try to prevent the material from entering drains or water courses.

Contain spillage, and then collect with non-combustible absorbent material and place in container for disposal. Keep in suitable, closed containers for disposal.

Materials: non-combustible absorbent material (e.g. sand, earth, diatomaceous earth, vermiculite)

When using, do not eat, drink or smoke. For personal protection see section 8. Use only in well-ventilated areas. Do not breathe vapors or spray mist. Avoid contact with skin, eyes and clothing.

Keep away from food, drink and animal feedingstuffs. Keep in a bunded area. Keep container tightly closed. Keep preferably in the original container. Otherwise reproduce all indication of the regulation label on the new container. Protect from frost, heat and sunlight. Protect from moisture.

Ensure the application of strict rules of hygiene by the personnel exposed to the risk of contact with the product. Regular cleaning of equipment, work area and clothing is recommended. Wash hands before breaks and immediately after handling the product. Do not use abrasives, solvents or fuels. Do not dry hands with rags that have been contaminated with product. Do not put product contaminated rags into workwear pockets.

Take precautionary measures against static discharges. Ground/bond containers, tanks and transfer/receiving equipment.

Apply technical measures to comply with the occupational exposure limits. When working in confined spaces (tanks, containers, etc.), ensure that there is a supply of air suitable for breathing and wear the recommended equipment.

Protective gloves: Fluorinated rubber. Nitrile rubber. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. If used in solution, or mixed with other substances, and under conditions which differ from EN 374, contact the supplier of the EC approved gloves.

If splashes are likely to occur, wear:. Safety glasses with side-shields.

None under normal use conditions. In case of vapours and aerosol formation:. Respirator with combination filter for vapour/particulate (EN 14387). The use of breathing apparatus must comply strictly with the manufacturer's instructions and the regulations governing their choices and uses.

Wear suitable protective clothing. Protective shoes or boots. Long sleeved clothing.

The product should not be allowed to enter drains, water courses or the soil.

Stable under recommended storage conditions.

No information available.

None under normal processing.

Heat (temperatures above flash point), sparks, ignition points, flames, static electricity.

Strong oxidizing agents.

None under normal use.