CYCLOHEXAN LU

Keep patient calm, remove to fresh air, seek medical attention.

Symptoms: When inhaled (e.g. during vomiting) risk of pulmonary oedema and/or pneumonia.

Immediately wash thoroughly with soap and water, seek medical attention.

Wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.

Immediately rinse mouth and then drink 200-300 ml of water, seek medical attention.

dry powder, water spray, carbon dioxide, foam

water jet

Highly flammable.

Use extinguishing measures to suit surroundings.

Handle in accordance with good industrial hygiene and safety practice. Avoid contact with the skin, eyes and clothing. Take off immediately all contaminated clothing.

Discharge into the environment must be avoided.

Pick up with suitable appliance and dispose of.

Handle in accordance with good industrial hygiene and safety practice.

Keep container tightly closed in a cool, well-ventilated place.

Handle in accordance with good industrial hygiene and safety practice.

Avoid all sources of ignition: heat, sparks, open flame. Ground all transfer equipment properly to prevent electrostatic discharge.

Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding >480 minutes of permeation time according to EN ISO 374-1): fluoroelastomer (FKM) - 0.7 mm coating thickness, nitrile rubber (NBR) - 0.4 mm coating thickness. Suitable materials for short-term contact (recommended: At least protective index 2, corresponding >30 minutes of permeation time according to EN ISO 374-1) chloroprene rubber (CR) - 0.5 mm coating thickness, butyl rubber (butyl) - 0.7 mm coating thickness. Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in practice may be much shorter than the permeation time determined through testing. Manufacturer's directions for use should be observed because of great diversity of types.

Safety glasses with side-shields (frame goggles) (e.g. EN 166)

Wear respiratory protection if ventilation is inadequate. Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g. EN 14387 Type A)

Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

All appropriate measures must be taken to prevent the release of this product to the environment and to limit the dispersion of any release when it occurs. Suitable risk management measures should be in place.

The product is stable if stored and handled as prescribed/indicated. Peroxides: The product/the substance has not a tendency towards the formation of peroxide.

No hazardous reactions if stored and handled as prescribed/indicated., When heated can give off ignitable vapours., Vapours may form explosive mixture with air. Corrosion to metals: No corrosive effect on metal.

No hazardous reactions if stored and handled as prescribed/indicated.

Avoid all sources of ignition: heat, sparks, open flame.

strong oxidizing agents

No hazardous decomposition products if stored and handled as prescribed/indicated.

Tunnel code: D/E