tert-Butyl methyl ether

After inhalation: fresh air.

Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Remove contact lenses.

After swallowing: caution if victim vomits. Keep airways free. Call a physician immediately.

Symptoms: Risk of aspiration! Pulmonary failure possible after aspiration of vomit.

Carbon dioxide (CO2) Foam Dry powder

For this substance/mixture no limitations of extinguishing agents are given.

Combustible. Pay attention to flashback. Vapors are heavier than air and may spread along floors. Development of hazardous combustion gases or vapours possible in the event of fire. Forms explosive mixtures with air at ambient temperatures.

Stay in danger area only with self-contained breathing apparatus. Prevent skin contact by keeping a safe distance or by wearing suitable protective clothing.

Do not breathe vapors, aerosols. Avoid substance contact. Ensure adequate ventilation. Keep away from heat and sources of ignition. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains. Risk of explosion.

Take up with liquid-absorbent material (e.g. Chemizorb®). Clean up affected area.

Materials: liquid-absorbent material (e.g. Chemizorb®)

Keep away from open flames, hot surfaces and sources of ignition. Take precautionary measures against static discharge.

Keep container tightly closed in a dry and well-ventilated place. Keep away from heat and sources of ignition.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Keep away from open flames, hot surfaces and sources of ignition.

This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Splash contact Material: Nitrile rubber Minimum layer thickness: 0,4 mm Break through time: 120 min Material tested: Camatril® (KCL 730 / Aldrich Z677442, Size M)

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when vapours/aerosols are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter type AX The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

Flame retardant antistatic protective clothing.

Do not let product enter drains. Risk of explosion.

The product is chemically stable under standard ambient conditions (room temperature).

Vapors may form explosive mixture with air.

Violent reactions possible with: Oxidizing agents, Strong acids, halogens, Strong bases, rubber, various plastics

Heat, flames and sparks. Warming.

No data available

In the event of fire: see section 5