Ammonium chloride for analysis EMSURE® ACS,ISO,Reag. Ph Eur

After inhalation: fresh air.

Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Call in ophthalmologist. Remove contact lenses.

After swallowing: immediately make victim drink water (two glasses at most). Consult a physician.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

For this substance/mixture no limitations of extinguishing agents are given.

Not combustible. Fire may cause evolution of: nitrogen oxides, Hydrogen chloride gas. Ambient fire may liberate hazardous vapours.

Suppress (knock down) gases/vapors/mists with a water spray jet.

Avoid inhalation of dusts. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Take up dry. Clean up affected area.

For precautions see section 2.2.

Tightly closed. Dry. Recommended storage temperature see product label.

This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Full contact Material: Nitrile rubber Minimum layer thickness: 0,11 mm Break through time: 480 min Material tested: KCL 741 Dermatril® L. Splash contact Material: Nitrile rubber Minimum layer thickness: 0,11 mm Break through time: 480 min Material tested: KCL 741 Dermatril® L

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter type P2. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

No data available

Violent reactions possible with: alkali hydroxides, acids. Risk of ignition or formation of inflammable gases or vapours with: halogen-halogen compounds, alkalines, alkaline substances. Risk of explosion with: nitrates, chlorates, Heavy metal salts, nitrites, Hydrogen cyanide (hydrocyanic acid), Chlorine, silver salt. Strong oxidizing agents.

no information available

Aluminum, Lead, Iron, Copper, copper compounds

In the event of fire: see section 5