Metallotion PROTEC CE15L+

Supply person with fresh air and consult doctor according to symptoms.

Remove polluted, soaked clothing immediately, wash thoroughly with plenty of water and soap, in case of irritation of the skin (flare), consult a doctor.

Symptoms: irritation of the skin (flare)

Remove contact lenses. Wash thoroughly for several minutes using copious water. Seek medical help if necessary.

Rinse the mouth thoroughly with water. Do not induce vomiting. Consult doctor immediately.

Adapt to the nature and extent of fire. Water jet spray/foam/CO2/dry extinguisher

High volume water jet

In case of fire the following can develop: Oxides of carbon, Oxides of nitrogen, Toxic gases

According to size of fire

Leave the danger zone if possible, use existing emergency plans if necessary.

If leakage occurs, dam up. Resolve leaks if this possible without risk.

Soak up with absorbent material, Flush residue using copious water.

Materials: universal binding agent, sand, diatomaceous earth, sawdust

Avoid contact with eyes or skin. Observe directions on label and instructions for use. Use working methods according to operating instructions.

Keep out of access to unauthorised individuals. Not to be stored in gangways or stair wells. Store product closed and only in original packing. Store at room temperature. Protect from frost.

General hygiene measures for the handling of chemicals are applicable. Wash hands before breaks and at end of work. Keep away from food, drink and animal feedingstuffs. Remove contaminated clothing and protective equipment before entering areas in which food is consumed. Eating, drinking, smoking, as well as food-storage, is prohibited in work-room.

Ensure good ventilation. This can be achieved by local suction or general air extraction. If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn.

Chemical resistant protective gloves (EN ISO 374). If applicable: Protective gloves in butyl rubber (EN ISO 374). Protective Neoprene® / polychloroprene gloves (EN ISO 374). Protective nitrile gloves (EN ISO 374). Minimum layer thickness in mm: 0,5. Permeation time (penetration time) in minutes: 480. The breakthrough times determined in accordance with EN 16523-1 were not obtained under practical conditions. The recommended maximum wearing time is 50% of breakthrough time. Protective hand cream recommended. Additional information on hand protection - No tests have been performed. In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents. Selection of materials derived from glove manufacturer's indications. Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account. Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to manufacturer. In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use. The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.

Tight fitting protective goggles (EN 166) with side protection, with danger of splashes.

Normally not necessary.

Protective working garments (e.g. safety shoes EN ISO 20345, long-sleeved protective working garments).

No information available at present.

Stable with proper storage and handling.

The product has not been tested.

No dangerous reactions are known.

None known

Avoid contact with strong alkalis. Avoid contact with strong acids. Avoid contact with strong oxidizing agents.

No decomposition when used as directed.