Pelco® Colloidal Silver

Remove from exposure to fresh air immediately. Get medical aid if cough or other symptoms appear.

Symptoms: No adverse effects are anticipated from inhalation.

Wash with water and soap and rinse thoroughly. Wash area thoroughly with soap and water. Get medical aid if irritation develops or persist.

Flush immediately with large amounts of water for at least 15 minutes. Eyelids should be held away from the eyeball to ensure thorough rinsing. Get medical attention if irritation persists.

Do not induce vomiting. Never give anything by mouth to an unconscious person. If victim is conscious and alert, give 2-4 cups of milk or water. Get medical aid.

CO₂, foam, dry chemical, water.

Water with full jet

During heating or in case of fire poisonous gases are produced. Unusual Fire and Explosion Hazards: Can burn in fire, releasing toxic vapours. Vapourised easily at normal temperatures. DOT class: Flammable.

As in any fire, wear self-contained breathing apparatus pressure-demand, (MSHA/NIOSH approved or equivalent) and full protective gear.

For an uncontrolled release of this product to the environment, take immediate steps to stop and contain release.

Do not allow to enter sewers/ surface or ground water. For an uncontrolled release of this product to the environment, take immediate steps to stop and contain release.

Clean up with rags or paper and place in container for refining.

Materials: rags or paper

Ensure good ventilation/exhaustion at the workplace. Open and handle receptacle with care. Prevent formation of aerosols. Avoid contact with skin and eyes. Wash thoroughly after handling. Keep container tightly closed when not in use.

Keep container tightly closed when not in use.

Wash thoroughly after handling.

Protect against electrostatic charges.

Good general ventilation should be sufficient to control airborne levels.

Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Tightly sealed goggles

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

Store protective clothing separately.

Stable under normal conditions of use.

No further relevant information available.

No dangerous reactions known.

Strong oxidizers, acids and alkali.

No decomposition if used according to specifications.