Tangit PVC-U Special Adhesive (formerly known as Tangit ALL PRESSURE)

Move to fresh air, consult doctor if complaint persists.

Symptoms: Irritation, coughing, shortness of breath, chest tightness. Vapors may cause drowsiness and dizziness.

Rinse with running water and soap. Skin care. Remove contaminated clothes immediately.

Symptoms: Redness, inflammation.

Rinse immediately with plenty of running water (for 10 minutes), seek medical attention from a specialist.

Symptoms: Corrosive, may cause permanent damage to eyes (impairment of vision).

Rinse mouth, do not induce vomiting, consult a doctor.

carbon dioxide, foam, powder, water spray jet, fine water spray

High pressure waterjet

In the event of a fire, carbon monoxide (CO) and carbon dioxide (CO2) can be released.

Cool endangered containers with water spray jet.

Ensure adequate ventilation. Avoid contact with skin and eyes. Wear protective equipment. Danger of slipping on spilled product.

Do not empty into drains / surface water / ground water.

Remove with liquid-absorbing material

Materials: sand, peat, sawdust

Avoid naked flames, sparking and sources of ignition. Switch off electrical devices. Do not smoke, do not weld. Avoid skin and eye contact.

Store in a cool place in closed original container. Temperatures between +5 °C and +35 °C.

Do not eat, drink or smoke while working. Wash hands before work breaks and after finishing work.

Avoid naked flames, sparking and sources of ignition. Switch off electrical devices. Do not smoke, do not weld. Avoid all sources of fire such as stoves and ovens. Switch off all electrical devices such as parabolic heaters, hot plates, storage heaters etc. in good time for them to have cooled down before commencing work. Avoid all sparks, including those occurring at electrical switches and devices.

Recommended are gloves made from Nitril rubber (Material thickness >0,1 mm, Perforation time < 30s). Gloves should be replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's shops. In the case of longer contact protective gloves made from butyl rubber are recommended according to EN 374. material thickness > 0,3 mm. Perforation time > 10 minutes. In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.

Goggles which can be tightly sealed. Protective eye equipment should conform to EN166.

Suitable breathing mask when there is inadequate ventilation. Combination filter: ABEKP (EN 14387) This recommendation should be matched to local conditions.

Suitable protective clothing. Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.

Stable under recommended storage conditions.

None if used for intended purpose.

See section reactivity

None if used for intended purpose.

None if used properly.

None known