Tangit Cleaner PVC-U/C ABS

Move to fresh air, consult doctor if complaint persists.

Symptoms: Vapors may cause drowsiness and dizziness.

Rinse with running water and soap. Skin care. Remove contaminated clothes immediately.

Symptoms: Repeated exposure may cause skin dryness or cracking.

Immediately flush eyes with soft jet of water or eye rinse solution for at least 5 minutes. If pains remain (intensive smarting, sensitivity to light, visual disturbance) continue flushing and contact/seek doctor or hospital.

Symptoms: Causes serious eye irritation.

Rinse mouth, do not induce vomiting, consult a doctor.

carbon dioxide, foam, powder, water spray jet, fine water spray

High pressure waterjet

In the event of a fire, carbon monoxide (CO) and carbon dioxide (CO2) can be released.

Cool endangered containers with water spray jet.

Wear protective equipment. Danger of slipping on spilled product. Avoid contact with skin and eyes. Ensure adequate ventilation.

Do not empty into drains / surface water / ground water.

Remove with liquid-absorbing material (sand, peat, sawdust).

Materials: sand, peat, sawdust

Ventilate working rooms thoroughly. Avoid naked flames, sparking and sources of ignition. Switch off electrical devices. Do not smoke, do not weld. Do not empty waste into waste water drains. During processing and drying after adhesion, ventilate well. Avoid all sources of fire such as stoves and ovens. Switch off all electrical devices such as parabolic heaters, hot plates, storage heaters etc. in good time for them to have cooled down before commencing work. Avoid all sparks, including those occurring at electrical switches and devices. Avoid skin and eye contact.

Ensure adequate ventilation. Close the container carefully after use and store it at a good ventilated place. Store protected from heat influence. Temperatures between 0 °C and + 35 °C. Keep only in original container. Do not store together with food or other consumables (coffee, tea, tobacco, etc.).

Do not eat, drink or smoke while working. Wash hands before work breaks and after finishing work.

Avoid naked flames, sparking and sources of ignition. Switch off electrical devices. Do not smoke, do not weld. Avoid all sources of fire such as stoves and ovens. Switch off all electrical devices such as parabolic heaters, hot plates, storage heaters etc. in good time for them to have cooled down before commencing work. Avoid all sparks, including those occurring at electrical switches and devices.

The product should only be used at workplaces with intensive ventilation/extraction.

For shorttime contact (1-5 minutes) protective gloves made from special nitrile rubber are recommended according to EN 374. Material thickness > 0,2 mm. In the case of longer contact protective gloves made from butyl rubber are recommended according to EN 374. material thickness > 0.7 mm. Perforation time > 240 minutes. In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced immediately at the first signs of wear and tear.

Goggles which can be tightly sealed. Protective eye equipment should conform to EN166.

If intensive ventilation/extraction is not possible then self-contained independent respiratory protection should be worn.

Suitable protective clothing. Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.

Stable under recommended storage conditions.

None if used for intended purpose.

See section reactivity

None if used for intended purpose.

None if used properly.

None known.

Dispose of waste and residues in accordance with local authority requirements.