Peran STC/TCW/LVS Part B

Remove person to fresh air. If signs/symptoms continue, get medical attention.

Symptoms: Harmful by inhalation

Use a mild soap if available. Consult a physician. Do not use solvent or thinners to clean skin. Immediate medical treatment is necessary as untreated wounds from corrosion of the skin heal slowly and with difficulty. Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes.

Symptoms: Causes burns. May cause sensitization by skin contact.

Immediate medical attention is required. Keep eye wide open while rinsing. Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses.

Symptoms: Causes serious eye damage.

Gently wipe or rinse the inside of the mouth with water. If conscious, drink plenty of water. Never give anything by mouth to an unconscious person. If swallowed, seek medical advice immediately and show this container or label. If swallowed, DO NOT induce vomiting unless directed to do so by medical personnel.

Symptoms: Harmful if swallowed.

Carbon Dioxide, Dry Chemical, Foam

Do not use a solid water stream as it may scatter and spread fire. Alcohol, Alcohol based solutions, any other media not listed above.

In case of fire hazardous decomposition products may be produced such as: Carbon dioxide (CO2), carbon monoxide (CO), oxides of nitrogen (NOx), dense black smoke.

Keep containers and surroundings cool with water spray.

Avoid contact with skin, eyes and clothing. For personal protection see section 8.2. Ensure adequate ventilation. Keep people away from and upwind of spill/leak.

Discharge into the environment must be avoided.

soak up with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and transfer to a container for disposal according to local / national regulations (see section 13).

Materials: non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite)

Wear personal protective equipment. Do not breathe vapours or spray mist. Avoid contact with skin and eyes. People handling epoxy products must have received special training according to guidelines from the National Occupational Health and Safety Board. In the case of sensitisation to any of the ingredients, it is inadvisable to work with the product.

Keep out of the reach of children. Keep at temperatures between 15 and 30 °C. Store in original container. Keep container tightly closed in a dry and well-ventilated place. Keep container closed when not in use. Keep away from food, drink and animal feeding stuffs.

Handle in accordance with good industrial hygiene and safety practice. Keep working clothes separately. Keep away from food, drink and animal feedingstuffs. Wash hands before breaks and at the end of workday. When using, do not eat, drink or smoke.

Avoid contact with sources of heat.

Ensure adequate ventilation, especially in confined areas.

Use chemical resistant gloves (EN 374): Nitrile rubber; thickness >=0,5 mm; breakthrough time >= 480 min. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough. Take note of the information given by the producer concerning permeability and break through times, and of special workplace conditions (mechanical strain, duration of contact). Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature).

Eye wash bottle with pure water. Face-shield. Safety glasses with side-shields conforming to EN 166.

No personal respiratory protective equipment normally required. In case of insufficient ventilation wear suitable respiratory equipment, filter ABEK-P2.

Long sleeved clothing. Remove and wash contaminated clothing before re-use.

No decomposition if stored and applied as directed.

No reactivity hazards known under recommended storage and use conditions.

Exothermic reaction with strong acids.

Avoid temperatures above 40 °C, direct sunlight and contact with sources of heat. Do not freeze.

Acids. Oxidizing agents.

Carbon dioxide (CO2), carbon monoxide (CO), oxides of nitrogen (NOx), dense black smoke.