WD-40® MULTI-USE PRODUCT

Supply person with fresh air. Remove person from danger area. Respiratory arrest - Artificial respiration apparatus necessary.

Symptoms: Headaches, Nausea, Dizziness, Irritation of the respiratory tract, Effects/damages the central nervous system

Remove polluted, soaked clothing immediately, wash thoroughly with plenty of water and soap.

Symptoms: irritation of the skin (flare)

Remove contact lenses. Wash thoroughly for several minutes using copious water.

Symptoms: Irritation of the eyes

Rinse the mouth thoroughly with water. Do not induce vomiting.

Symptoms: Danger of aspiration

Foam, CO2, Extinction powder

Water

Danger of bursting (explosion) when heated. Danger of explosion by prolonged heating. Explosive vapour/air mixture.

Cool container at risk with water.

Remove possible causes of ignition - do not smoke. Ensure sufficient supply of air. Avoid inhalation, and contact with eyes or skin. Do not carry cleaning cloths soaked in product in trouser pockets.

If leakage occurs, dam up. Resolve leaks if this possible without risk.

Soak up with absorbent material

Ensure good ventilation. Keep away from sources of ignition - Do not smoke. Do not use on hot surfaces. Observe directions on label and instructions for use. Use working methods according to operating instructions. Take measures against electrostatic charging, if appropriate.

Keep out of access to unauthorised individuals. Not to be stored in gangways or stair wells. Observe special regulations for aerosols! Observe special storage conditions (in Germany, e.g., in accordance with the regulations in the "Betriebssicherheitsverordnung"). Keep protected from direct sunlight and temperatures over 50°C. Store in a dry place. Store cool. Store in a well ventilated place.

General hygiene measures for the handling of chemicals are applicable. Wash hands before breaks and at end of work. Keep away from food, drink and animal feedingstuffs. Remove contaminated clothing and protective equipment before entering areas in which food is consumed.

Keep away from sources of ignition - Do not smoke. Take measures against electrostatic charging, if appropriate.

Ensure good ventilation. This can be achieved by local suction or general air extraction. If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn.

Protective nitrile gloves (EN 374) Minimum layer thickness in mm: >= 0,4 Permeation time (penetration time) in minutes: >= 480 The breakthrough times determined in accordance with EN 374 Part 3 were not obtained under practical conditions. The recommended maximum wearing time is 50% of breakthrough time. Protective hand cream recommended. Additional information on hand protection - No tests have been performed. In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents. Selection of materials derived from glove manufacturer's indications. Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account. Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to manufacturer. In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use. The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.

Tight fitting protective goggles with side protection (EN 166).

Normally not necessary. If OES or MEL is exceeded. Filter A P 3 (EN 14387), code colour brown, white. Observe wearing time limitations for respiratory protection equipment.

Protective working garments (e.g. safety shoes EN ISO 20345, long-sleeved protective working garments)

No information available at present.

Stable with proper storage and handling.

The product has not been tested.

No dangerous reactions are known.

Heating, open flame, ignition sources. Pressure increase will result in danger of bursting. Pressurized container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do not pierce or burn, even after use.

Avoid contact with strong oxidizing agents.

No decomposition when used as directed.