Titanium Sponge Powders

remove a poisoned person from the affected area, remove polluted clothing. Fresh air, rest, warm.

Symptoms: Inhalation of dust (aerosol) causes throat irritation, cough, respiratory affection, chest pain.

remove a poisoned person from the affected area, remove polluted clothing, remove excess product by a cotton disc, wash with running water with a soap.

Symptoms: There is no irritant action at a single and repeated contacts.

wash wide-open eyes with running water.

Symptoms: Eye contact with dust (aerosol) causes possible mechanical irritation (eye watering, light conjunctiva redness).

rinse a mouth with water, drink a plenty of water, take activated carbon, saline purge (sodium sulfate).

Symptoms: When ingested mechanical irritation is possible - nausea, vomiting, weakness, abdominal pain, diarrhea

Dry sand, potassium chloride or sodium chloride or their mixture, dolomite powder [1]; magnesium oxide, powder composition PKH [20].

Water, foam extinguishers, because water decomposition with production of hydrogen will take place, which will intensify the burning process [20].

Auto-ignition temperature ( T_{ai} ) 510°C. Lower flammable limit (LFL) 60 g·m ^{-3} . Rate of flame spread is no more than 1 mm/s [1]. The minimum ignition energy is 25 mJ. [61]. Auto-ignition temperature: in carbon dioxide is 680°C, in air 320°C. The maximum explosion pressure is 640 kPa in the air, 2460 kPa in oxygen. The maximum rate of pressure rise is 77 MPa/c. The minimum explosive oxygen content (MEOK) is 1.5% (vol.) at dust mixture dilution with nitrogen [20].

Do not approach the burning tanks. Cool substance tanks using water at a maximum range.

Get a vehicle to a safe place. Isolate the danger zone within a radius of at least 200 m. Adjust this distance by results of chemical reconnaissance. Remove unauthorized persons. Enter the danger zone only equipped with the personal protective equipment. Observe the fire safety measures. Do not smoke. Eliminate sources of heat and sparks. Provide first aid to the injured [17].

Do not allow substance enter water bodies and sewage.

For outdoor spills: cut the superficial layer of soil with pollution, collect and remove it for disposal. For indoor spills: covered with inert material, collected into a container and sent to the production line for processing.

Materials: inert material

When working with finished goods general fire safety rules must be observed: use explosion-proof equipment and lighting; to avoid static electricity, equipment must be grounded; primary fire extinguishing agents should be available at the workplaces. Spark proof tools must be used at all operations.

The product packed in air-tight containers, is stored in a warehouse of the consignor (consignee), equipped with fire control system.

use explosion-proof equipment and lighting; to avoid static electricity, equipment must be grounded; primary fire extinguishing agents should be available at the workplaces. Spark proof tools must be used at all operations.

Air-tightness of the production process and production equipment. The production areas are to be equipped with a balanced ventilation system; areas of potential titanium aerosol occurrence – with local exhaust devices.

10.1. Chemical stability (it is necessary to specify decomposition product for non-stable products)

Oxidizes, halogenates, hydrogenates; reacts with hydrochloric acid, sulfuric acid, trichloro- and trifluoroacetic acid, a boiling water [7,30,31].

sources of ignition, heat, sparks, open flame [1,7,30,31].

oxidizing agents, acids, alkalis

Transport emergency card F-G, S-G