Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- TEROSON EV 13007 2x30x330MM 542599706314
- Product Code
- 3107024
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Sealant
Uses advised against
None identified
Manufacturers & Suppliers
Henkel Corporation
manufacturer
One Henkel Way, Rocky Hill, Connecticut 06067
+1 (860) 571-5100
http://www.henkelina.com
Emergency Contacts
Poison Control Center
1-877-671-4608
Poison Control Center
1-303-592-1711
CHEMTREC
1-800-424-9300
CHEMTREC
1-703-527-3887
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS07
GHS08
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| dodecairon strontium nonadecaoxide | 12023-91-5 | 30 - 60% | No |
| CP Bisphenol A Diglycidyl ether | 25036-25-3 | 5 - 10% | No |
| Propylidynetrimethyl trimethacrylate | 3290-92-4 | 5 - 10% | No |
| Epichlorohydrin-4,4'-isopropylidene diphenol resin | 25068-38-6 | 1 - 5% | No |
| Zinc oxide | 1314-13-2 | 1 - 5% | No |
| bis(α, α-dimethylbenzyl)peroxide | 80-43-3 | 0.1 - 1% | No |
First Aid Measures
Emergency procedures for chemical exposure incidents
If mist or vapor of this product is inhaled, remove person immediately to fresh air. Seek medical attention if symptoms develop or persist.
Immediately wash skin thoroughly with soap and water. Obtain medical attention if irritation persists.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Get immediate medical attention.
Immediate Medical Attention
Get immediate medical attention.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Water spray (fog), foam, dry chemical or carbon dioxide.
Not available.
None identified.
Wear full protective clothing. Wear self-contained breathing apparatus.
Firefighter Protection
Wear full protective clothing. Wear self-contained breathing apparatus.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.
Wear appropriate protective equipment and clothing during clean-up. Do not allow product to enter sewer or waterways. Remove all sources of ignition.
Absorb spill with inert material. Shovel material into appropriate container for disposal. Dispose of according to Federal, State and local governmental regulations.
Materials: inert material
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Avoid breathing fumes if this product is used at high temperatures. Use only with adequate ventilation. Do not take internally. For industrial use only.
Not available.
Wash thoroughly after handling.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable at normal conditions.
Not available.
Will not occur.
Reaction with some curing agents may produce considerable heat. Run-a-way cure reactions (polymerization) may char and decompose the resin system. Fumes and vapors from these thermal and chemical decompositions vary widely in composition and toxicity. Avoid excessive heat and ignition sources.
This product may react with strong acids or oxidizing agents.
Irritating and/or toxic fumes and gases may be emitted upon the product's decomposition. Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for TEROSON EV 13007 2x30x330MM 542599706314?
The signal word is danger.
What is the physical form of TEROSON EV 13007 2x30x330MM 542599706314?
TEROSON EV 13007 2x30x330MM 542599706314 is a solid with black color. It has mild odor.
What is the solubility of TEROSON EV 13007 2x30x330MM 542599706314?
Insoluble Water
What is TEROSON EV 13007 2x30x330MM 542599706314 used for?
Sealant
What are the hazard statements for TEROSON EV 13007 2x30x330MM 542599706314?
This substance has 4 hazard statements:
- H315: CAUSES SKIN IRRITATION.
- H317: MAY CAUSE AN ALLERGIC SKIN REACTION.
- H319: CAUSES SERIOUS EYE IRRITATION.
- H360: MAY DAMAGE FERTILITY OR THE UNBORN CHILD.
What is the melting point of TEROSON EV 13007 2x30x330MM 542599706314?
The melting point is Not applicable, Decomposes. and the boiling point is Not applicable, Decomposes before boiling point is reached.