INTERNATIONAL THINNER (GTA007 / T-5)

If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately.

Symptoms: Harmful if inhaled. Causes nose and throat irritation. Vapors may affect the brain or nervous system causing dizziness, headache or nausea.

In case of contact, immediately flush skin with soap and plenty of water. Get medical attention immediately.

Symptoms: Causes skin irritation. May be harmful if absorbed through the skin.

In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately.

Symptoms: Causes severe eye irritation.

If swallowed, immediately contact the Poison Control Centre. DO NOT induce vomiting unless instructed to do so by medical personnel. Never give anything by mouth to an unconscious person.

Symptoms: Harmful if swallowed. May cause abdominal pain, nausea, vomiting, diarrhea, or drowsiness.

SMALL FIRES: Use dry chemical, CO2, water spray or alcohol-resistant foam. LARGE FIRES: Use water spray, fog, or alcohol-resistant foam.

Do not use straight streams.

This product has a very low flashpoint.

Move containers from fire area if you can do so without risk.

No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilt material.

Consider initial downwind evacuation for at least 300 meters (1000 feet).

Do not allow spills to enter drains or watercourses.

Keep away from heat, sparks and flame. Protective equipment should be selected to provide protection from exposure to the chemicals listed in Section 3 of this document. Depending on the site-specific conditions of use, protective gloves, apron, boots, head and face protection may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use. Close container after each use. Wash thoroughly after handling.

Close container after each use.

Wash thoroughly after handling.

Keep away from heat, sparks and flame.

Depending on the site-specific conditions of use, provide adequate ventilation.

Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products.

Avoid contact with eyes. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts. If contact is possible, the following protection should be worn, unless the assessment indicates a higher degree of protection: chemical splash goggles.

Select equipment to provide protection from the ingredients listed in Section 3 of this document. Ensure fresh air entry during application and drying. If you experience eye watering, headache or dizziness or if air monitoring demonstrates dust, vapor, or mist levels are above applicable limits, wear an appropriate, properly fitted respirator (NIOSH approved) during and after application. Follow respirator manufacturer's directions for respirator use. FOR USERS OF 3M RESPIRATORY PROTECTION ONLY: For information and assistance on 3M occupational health and safety products, call OH&ESD Technical Service toll free in U.S.A. 1-800-243-4630, in Canada call 1-800-267-4414. Please do not contact these numbers regarding other manufacturer's respiratory protection products. 3M does not endorse the accuracy of the information contained in this Material Safety Data Sheet.

When there is a risk of ignition from static electricity, wear antistatic protective clothing and footwear. Any additional personal protective equipment or measures should be selected based on the risk assessment of the task being performed and should be approved by a specialist before handling this product.

This product is stable.

No data available

hazardous polymerization will not occur.

Excessive heat

Strong oxidizing agents.

fumes