Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- GLOBALPRENE® SBS
- Product Code
- 3411, 3411P, 3501, 3501W, 3501U, 3502U, 3540, 3542 3545, 3546U, 3546, 3566, 3710
- Chemical Name
- Benzene, ethenyl-, polymer with 1,3-butadiene
Regulatory Identifiers
- CAS Number
- 9003-55-8 Check regulations →
- EC Number
- 618-370-2 Check regulations →
- REACH No.
- 01-2119471988-16-0171 (Buta-1,3-diene), 01-2119457861-32-0153 (Styrene)
Identified Uses
Modified bitumen.
Uses advised against
Do not use in medical devices.
Manufacturers & Suppliers
LCY GRIT Corp.
Tradeboulevard 3, Moerdijk Distribution Center 3; 4761 RL Zevenbergen, Holandia
+31 418 666688
Emergency Contacts
Emergency Contact
112
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Benzene, ethenyl-, polymer with 1,3-butadiene EC: 618-370-2 | 9003-55-8 | 100% | No |
First Aid Measures
Emergency procedures for chemical exposure incidents
Remove affected person to fresh air and keep rested. Seek medical advice if there are worrisome symptoms.
Symptoms: Product dust may cause respiratory irritation.
Get immediate medical advice/attention.
Symptoms: It does not normally have any harmful effects on health. Contact with hot product may cause burns.
Remove any contact lenses. Wash contaminated eyes with plenty of water for at least few minutes, with eyelids rolled up. From time to time, overlap the upper eyelid with the lower eyelid. Seek medical advice if there are worrisome symptoms.
Symptoms: Eye contact can cause mechanical damage, mucous membrane irritation and tearing.
Ingestion is not a potential route of exposure. Seek medical advice if necessary.
Symptoms: Ingestion is not a potential route of exposure.
Immediate Medical Attention
In the event of health problems, consult your doctor or the centre of toxicological concern.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Water spray, foam, dry firefighting powders, carbon dioxide (CO$_{2}$).
Not specified.
Does not spontaneously ignite, flammable only when introduced to a fire source.
Containers exposed to fire or high temperature cool with water and if possible remove from the danger zone.
Firefighter Protection
Avoid inhalation of combustion products, because they may pose a health risk.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Access of non-emergency personnel to the area of accident should be restricted until the completion of the disposal of the product.
Secure the gullies. Prevent contamination of surface and ground water.
Sweep up the product, vacuum it or pick it up with a shovel to avoid dust build-up.
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Do not eat, drink, smoke or take drugs at work. Wash hands before break and after work with product. Wear appropriate personal protective equipment. Avoid sources of ignition. Avoid dust formation and accumulation. The product may accumulate static electricity.
Store in a cool, dry and well-ventilated area. Store at room temperature in a well-ventilated, covered storage area.
Do not eat, drink, smoke or take drugs at work. Wash hands before break and after work with product.
Avoid sources of ignition.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Provide adequate ventilation in the workplace with the product. Earth all equipment.
Wear protective gloves made of suitable material or leather in accordance with EN 374. When working with hot products, the use of heat-resistant gloves is required (EN 407).
Wear safety goggles with side protection in accordance with EN 166. Use suitable face protection when working with hot products.
Wear suitable respiratory protection if exposed to dust or fumes from the product.
Appropriate protective clothing and footwear should be worn.
The large amount of product should not be allowed to penetrate through the ground water, sewage, waste water or soil.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under normal conditions of storage.
May react with strong oxidising agents.
Not specified.
Avoid high temperatures, open flames, sparks, direct sunlight, ignition sources. Avoid contact with open flames and hot surfaces. Avoid accumulation of static electricity.
Avoid contact with strong oxidising agents.
None under normal conditions of use and storage.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Use personal protective equipment when handling the load - see section 8.
Use personal protective equipment when handling the load - see section 8.
Use personal protective equipment when handling the load - see section 8.
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for GLOBALPRENE® SBS?
The signal word is no signal word.
What is the physical form of GLOBALPRENE® SBS?
GLOBALPRENE® SBS is a solid material in the form of granules, crumbs or powder with white color. It has odourless odor.
What is the solubility of GLOBALPRENE® SBS?
Insoluble in water
What is GLOBALPRENE® SBS used for?
Modified bitumen.
What is the melting point of GLOBALPRENE® SBS?
The melting point is Not specified and the boiling point is Not specified.