OSI 935

In the event of inhalation, move patient to the open air. Keep warm and at rest. If breathing is irregular or has stopped, proceed with artificial respiration and seek medical attention.

Watch out for any remaining product between skin and clothing, watches, shoes, etc. In case of burns: COOL IMMEDIATELY WITH PLENTY OF WATER IN WAITING FOR TRANSPORT EMERGENCY HOSPITAL SPECIALIST. In case of burns with adhesion of the full member or finger circumference must carefully cut the sleeve can be formed when the product cools. Do not remove the layer adhering to the skin, the affected area are likely to be torn; usually the product stands on its own after a few days. Do not break blisters.

If splashed hot in the eyes, COOL IMMEDIATELY WITH PLENTY PLENTY OF WATER, by removing the lids if possible, for 10 minutes and transported in a specialized hospital.

In the event of swallowing, if the quantity is small (no more than one mouthful), rinse the mouth with water and consult a doctor. Keep the person exposed at rest. Do not force vomiting. Seek medical attention, showing the label.

sprayed water or water mist, foam, multipurpose ABC powder, BC powder, carbon dioxide (CO2), dry sand

water jet

A fire will often produce a thick black smoke. Exposure to decomposition products may be hazardous to health. The contact between the hot product ( >100°C ) and the water or aqueous product causes rapid vaporization of the water with foaming and overflow hot product.

Consult the safety measures listed under headings 7 and 8.

Contain and control the leaks or spills with non-combustible absorbent materials such as sand, earth, vermiculite, diatomaceous earth in drums for waste disposal. Prevent any material from entering drains or waterways.

Retrieve the product by mechanical means (sweeping/vacuuming).

Always wash hands after handling. Avoid contact with hot material. Maintain product temperature as low as possible to minimize the emission of smoke. Hydrogen sulfide may accumulate in surface tanks containing this product and can reach potentially dangerous levels. Observe precautions stated on label and also industrial safety regulations. Packages which have been opened must be reclosed carefully and stored in an upright position. Prohibit loading rain and limit the flow speed of the product, especially at the beginning of loading.

Packages which have been opened must be reclosed carefully and stored in an upright position.

No smoking, eating or drinking in areas where the substance is used. Always wash hands after handling.

Do not heat pumps or pipes with an open flame. Do not heat the asphalt without special precautions in the temperature range 90-120 ° (risk of foaming spray or related to the accidental presence of water). NEVER heat a tank or tank if the heating elements are not widely covered (minimum 15cm).

Ensure that there is adequate ventilation, especially in confined areas.

Wear suitable protective gloves in the event of prolonged or repeated skin contact. Recommended properties : - Protective gloves against thermal risks in accordance with standard EN407

Avoid contact with eyes. Helmet with a visor and a neck guard (full head protection).

Particle filter according to standard EN143 : - B type (grey))

Suitable type of protective boots : Non-slip safety boot heat resistant (exemple leather).

Prevent material from entering sewers, waterways or soil.

This substance is stable under the recommended handling and storage conditions in section 7.

No data available.

Splashing contact with the hot asphalt with water.

high temperatures

water

carbon monoxide and dioxide, fumes and nitrogen oxide