Crystal Rinse

Let sit upright, fresh air, rest and take to hospital.

Remove contaminated clothing, rinse skin with plenty of water, if necessary seek medical attention.

Thoroughly rinse with water (contact lenses to be removed if this is easily done) then take to physician.

Symptoms: Redness

Rinse mouth, do not induce vomiting, take to hospital immediately.

Symptoms: Diarrhoea, headache, abdominal cramps, sleepiness, vomiting

CO2, foam, powder, sprayed water

Do not walk into or touch spilled substances and avoid inhalation of fumes, smoke, dusts and vapours by staying up wind. Remove any contaminated clothing and used contaminated protective equipment and dispose of it safely.

Do not allow to flow into sewers or open water.

remove by using absorbent material

Materials: absorbent material

Handle with care to avoid spillage.

Keep in a sealed container in a closed, frost-free, ventilated room.

The level of protection and types of controls necessary will vary depending upon potential exposure conditions. Adequate ventilation should be provided so that exposure limits are not exceeded. For further information, check section 7.

Handling with nitril-gloves (EN 374). Breakthrough time: >480' Material thickness: 0,35 mm. Thoroughly check gloves before use. Take of the gloves properly without touching the outside with your bare hands. The manufacturer of the protective gloves has to be consulted about the suitability for a specific work station. Wash and dry your hands.

Keep an eye-rinse bottle within reach. Tight-fitting safety goggles. Wear a face shield and protective suit in case of exceptional processing problems.

Respiratory protection is not required. Use ABEK type gas masks in case of irritating exposure. If necessary, use with sufficient exhaust ventilation.

Wear impermeable clothing. The type of protective equipment depends on the concentration and amount of hazardous substances at the work station in question.

Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions. For further information, check sections 6 and 13.

Extremely high or low temperatures.

Stable under normal conditions.

Protect from sunlight and do not expose to temperatures exceeding + 50°C.

Under recommended usage conditions, hazardous decomposition products are not expected.