NextSDS Logo
Safety Data Sheet EN

Bomazym Mix

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Bomazym Mix
Product Code
220026

Regulatory Identifiers

CAS Number
N/A
UFI Code
XM1V-81C2-X00U-9FXA

Manufacturers & Suppliers

BOMA logo

BOMA

distributor

Noorderlaan 131, B2030 Antwerpen

003232313389

http://www.boma.eu/

Emergency Contacts

Emergency Contact

+32 70 245 245

Nationaal Vergiftigingen Informatie Centrum (NVIC)

+31 88 755 8000

Emergency Contact

+ 33 (0)1 45 42 59 59

Emergency Contact

(+352) 8002-5500

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Skin Irrit. Cat. 2 H315
Eye Dam. Cat. 1 H318

GHS Pictograms

GHS05 - Corrosive

GHS05

Hazard Statements

H315 Causes skin irritation.
H318 Causes serious eye damage.

Precautionary Statements

P264 Wash hands thoroughly after handling.
P280 Wear protective gloves, protective clothing, eye protection, face protection.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P310 Immediately call a POISON CENTER or doctor.
P362 + P364 Take off contaminated clothing and wash it before reuse.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Sodium carbonate EC: 207-838-8 497-19-8 70% Yes
Sodium Percarbonate EC: 239-707-6 15630-89-4 30% Yes
Disodium metasilicate EC: 229-912-9 --- 2% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Let sit upright, fresh air, rest and take to hospital.

Symptoms: Headache, dizziness, nausea, drowsiness, unconsciousness

Skin contact

Remove contaminated clothing, rinse skin with plenty of water and immediately transport to hospital.

Symptoms: Caustic, redness, pain, serious burns

Eye contact

Thoroughly rinse with water (contact lenses to be removed if this is easily done) then take to physician.

Symptoms: Caustic, redness, blurred vision, pain

Ingestion

Rinse mouth, take to hospital immediately.

Symptoms: Caustic, lack of breath, vomiting, blisters on lips and tongue, burning pain in mouth and throat, gullet and stomach

Immediate Medical Attention

Take to hospital immediately.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

CO2, foam, powder, sprayed water

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Do not walk into or touch spilled substances and avoid inhalation of fumes, smoke, dusts and vapours by staying up wind. Remove any contaminated clothing and used contaminated protective equipment and dispose of it safely.

Environmental

Do not allow to flow into sewers or open water.

Cleanup methods

remove by using absorbent material

Materials: absorbent material

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Handle with care to avoid spillage.

Storage

Keep in a sealed container in a closed, frost-free, ventilated room.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

The level of protection and types of controls necessary will vary depending upon potential exposure conditions. Adequate ventilation should be provided so that exposure limits are not exceeded. For further information, check section 7.

Hands

Handling with nitril-gloves (EN 374). Breakthrough time: >480' Material thickness: 0,35 mm. Thoroughly check gloves before use. Take of the gloves properly without touching the outside with your bare hands. The manufacturer of the protective gloves has to be consulted about the suitability for a specific work station. Wash and dry your hands.

Eyes

Keep an eye-rinse bottle within reach. Tight-fitting safety goggles. Wear a face shield and protective suit in case of exceptional processing problems.

Respiratory

Use with sufficient exhaust ventilation. If necessary, use an air-purifying face mask in case of respiratory hazards. Use the ABEK type as protection against these troublesome levels.

Skin/Body

Wear impermeable clothing. The type of protective equipment depends on the concentration and amount of hazardous substances at the work station in question.

Environmental

Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions. For further information, check sections 6 and 13.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Freezing Point
---
Partition Coefficient
Not applicable
Solidification Point
---
Softening Point
---
Density
---
Colour Intensity
---
Explosive Limits
---
Vapor Density
Not applicable
Physical State Data
solid
Solubility In Water
Completely soluble
Evaporation Rate
/
Boiling Point
---
Dynamic Viscosity
/
Solubility
---
Odor Threshold
---
Bulk Density
---
Molecular Weight
---
Auto Ignition Temperature
---
Upper Explosive Limit
---
Properties Status
---
Colour
white
Kinematic Viscosity
---
Lower Explosive Limit
---
Crystallisation Point
---
Form
---
Solubility In Fat
---
Flash Point
---
Metal Corrosion
---
Cloud Point
---
Voc Content
/
Appearance
Solid
Relative Density
---
Vapor Pressure
---
Physical State
Solid
State Under Standard Conditions
---
Decomposition Temperature
---
Ph
---
Melting Point
---
Flammability
Not applicable
Relative Evaporation Rate
---
Odor
characteristic
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Extremely high or low temperatures.

Reactivity

Stable under normal conditions.

Avoid

Protect from sunlight and do not expose to temperatures exceeding + 50°C.

Incompatible

Keep away from acids

Decomposition

Under recommended usage conditions, hazardous decomposition products are not expected.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Bomazym Mix?

The signal word is danger.

What is the physical form of Bomazym Mix?

Bomazym Mix is a solid appearing as solid with white color. It has characteristic odor.

What are the hazard statements for Bomazym Mix?

This substance has 2 hazard statements:

  • H315: Causes skin irritation.
  • H318: Causes serious eye damage.