5L CLEANLINE THICK BLEACH

Move affected person to fresh air at once. Get medical attention if any discomfort continues. Rinse nose and mouth with water.

Symptoms: May cause respiratory system irritation.

Remove contaminated clothing. Get medical attention if irritation persists after washing. Rinse immediately with plenty of water.

Symptoms: Causes severe burns. Prolonged contact causes serious tissue damage.

Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Get medical attention if irritation persists after washing. Show this Safety Data Sheet to the medical personnel. Rinse immediately with plenty of water.

Symptoms: This product is corrosive. May cause chemical eye burns. Corneal damage. Severe irritation, burning, tearing and blurred vision.

Do not induce vomiting. Rinse mouth thoroughly with water. Give plenty of water to drink. Keep affected person under observation. Get medical attention if any discomfort continues. Show this Safety Data Sheet to the medical personnel.

Symptoms: This product is corrosive. May cause chemical burns in mouth and throat. May cause stomach pain or vomiting.

The product is not flammable. Use fire-extinguishing media suitable for the surrounding fire. Foam, carbon dioxide or dry powder.

Do not use water jet as an extinguisher, as this will spread the fire.

Hazardous combustion products: Toxic gases or vapours. Chlorine. Hydrogen chloride (HCl). Oxides of carbon.

Avoid contact with skin, eyes and clothing.

Collect and dispose of spillage as indicated in Section 13. Do not discharge into drains or watercourses or onto the ground.

Flush away spillage with plenty of water. Absorb spillage with non-combustible, absorbent material. Absorb in vermiculite, dry sand or earth and place into containers. Flush contaminated area with plenty of water.

Materials: vermiculite, dry sand or earth

Wear protective clothing as described in Section 8 of this safety data sheet. Avoid contact with skin and eyes. Avoid inhalation of vapours and spray/mists. Do not mix with acid.

Store in tightly-closed, original container in a dry, cool and well-ventilated place. Protect from light. Store at temperatures between 5°C and 25°C. Keep out of the reach of children.

Good personal hygiene procedures should be implemented. Do not eat, drink or smoke when using this product. Provide eyewash station. Wash promptly with soap and water if skin becomes contaminated. Wash contaminated clothing before reuse. Use appropriate skin cream to prevent drying of skin.

Provide adequate ventilation.

Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. It is recommended that gloves are made of the following material: Polyvinyl chloride (PVC). Rubber (natural, latex). To protect hands from chemicals, gloves should comply with European Standard EN374.

Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. Unless the assessment indicates a higher degree of protection is required, the following protection should be worn: Tight-fitting safety glasses. Personal protective equipment for eye and face protection should comply with European Standard EN166.

Respiratory protection not required.

Wear appropriate clothing to prevent repeated or prolonged skin contact. Use appropriate skin cream to prevent drying of skin.

Avoid releasing into the environment.

Decomposes over time.

The reactivity data for this product will be typical of those for the following class of materials: Acids. Alkalis. Oxidising materials.

Generates toxic gas in contact with acid. Chlorine.

increase in temperature, certain metallic impurities, high initial concentration, fall in pH below 11 and exposure to light.

certain metallic impurities

Chlorine. Hydrogen chloride (HCl). Oxides of the following substances: Chlorine. Hypochlorous acid. Sodium chlorate