Trichloroacetic acid

After inhalation: fresh air. Call in physician.

In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower. Call a physician immediately.

After eye contact: rinse out with plenty of water. Immediately call in ophthalmologist. Remove contact lenses.

After swallowing: make victim drink water (two glasses at most), avoid vomiting (risk of perforation). Call a physician immediately.

Water, Foam, Carbon dioxide (CO2), Dry powder

For this substance/mixture no limitations of extinguishing agents are given.

Combustible. Vapours are heavier than air and may spread along floors. Forms explosive mixtures with air on intense heating. Development of hazardous combustion gases or vapours possible in the event of fire.

Suppress (knock down) gases/vapours/mists with a water spray jet.

Avoid inhalation of dusts. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Cover drains. Collect, bind, and pump off spills. Take up dry. Dispose of properly. Clean up affected area.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Store under nitrogen. Tightly closed. Dry.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Material : Viton® Break through time : 480 min Glove thickness : 0,7 mm Protective index : Full contact Manufacturer : KCL 890 Vitoject® Material : Nitrile rubber Break through time : 30 min Glove thickness : 0,4 mm Protective index : Splash contact Manufacturer : Camatril® (KCL 730 / Aldrich Z677442, Size M) Remarks : This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Tightly fitting safety goggles

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter : Filter type B type: The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

Acid-resistant protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

Forms explosive mixtures with air on intense heating. A range from approx. 15 Kelvin below the flash point is to be rated as critical. The following applies in general to flammable organic substances and mixtures: in correspondingly fine distribution, when whirled up a dust explosion potential may generally be assumed.

Risk of explosion with: silver salt; Exothermic reaction with: alkalines, alkali hydroxides, Amines; Violent reactions possible with: Strong oxidizing agents, sulfoxides, dimethyl sulfoxide, with Copper

Exposure to moisture, Heat, Strong heating.

No data available

In the event of fire: see section 5