Ionify System Reagent S4 (iSysR S4)

If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.

If on skin, rinse well with water. If on clothes, remove clothes.

Flush eyes with water as a precaution. Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist.

Keep respiratory tract clear. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician. Take victim immediately to hospital.

Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

High volume water jet

Do not allow run-off from fire fighting to enter drains or water courses.

Ensure adequate ventilation. Remove all sources of ignition. Evacuate personnel to safe areas. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas. Refer to protective measures listed in sections 7 and 8.

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so.

Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13).

Materials: non-combustible absorbent material

Avoid formation of aerosol. Do not breathe vapours/dust. For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Take precautionary measures against static discharges. Provide sufficient air exchange and/or exhaust in work rooms. Container may be opened only under exhaust ventilation hood. Open drum carefully as content may be under pressure.

Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Observe label precautions.

Avoid contact with skin, eyes and clothing. Wash hands before breaks and immediately after handling the product.

Do not spray on a naked flame or any incandescent material. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours). Use only explosion-proof equipment. Keep away from open flames, hot surfaces and sources of ignition.

Unless adequate local exhaust ventilation is provided or exposure assessment demonstrates that exposures are within recommended exposure guidelines.

In case of contact through splashing: Material: Nitrile rubber, Break through time: > 30 min, Glove thickness: > 0,11 mm. In case of full contact: Material: butyl-rubber, Break through time: > 480 min, Glove thickness: > 0,4 mm. Remarks: Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. This recommendation is only valid for the product mentioned in the safety data sheet and provided by us and for the application specified by us. The suitability for a specific workplace should be discussed with the producers of the protective gloves.

Eye wash bottle with pure water Tightly fitting safety goggles

Use respiratory protection unless adequate local exhaust ventilation is provided or exposure assessment demonstrates that exposures are within recommended exposure guidelines. Equipment should conform to EN 14387. Filter type: Organic gas and low boiling vapour type (AX)

Impervious clothing. Choose body protection according to the amount and concentration of the dangerous substance at the work place.

Stable under normal conditions.

No dangerous reaction known under conditions of normal use.

No decomposition if stored and applied as directed. Vapours may form explosive mixture with air.

Heat, flames and sparks.

Not applicable

No hazardous decomposition products are known.