SULPHUR DICHLORIDE

Move exposed person to fresh air. Lay patient down. Keep warm & at rest.

Symptoms: Cough, difficulty breathing, bronchospasm, pulmonary edema.

Get under emergency shower immediately. Remove all contaminated clothing as rapidly as possible while under the shower. If no safety shower is available flush the affected area with large amount of running water for at least 15 to 20 minutes. Dust the affected area with powdered sodium bi carbonate. In case of burns apply a dry sterile dressing.

Symptoms: Burns, dermal hypersensitivity reactions.

Immediately flush eyes with plenty of water for 15 minutes. Remove contact lenses if easily possible. The eyelids should be held open and away from the eyeball to ensure that all surface are flushed thoroughly.

Symptoms: Causes severe irritation to eyes, pain and eye burns. May cause chemical conjunctivitis and corneal damage.

If affected person is conscious, immediately give several glasses of water or lime water or milk of magnesia or plain milk. No attempt should be made to induce vomiting. Never give anything by mouth to an unconscious person.

Symptoms: May cause severe and permanent damage to the digestive tract. May lose consciousness; also there might be acid burns due to hydrolysis. Causes gastrointestinal tract burns and gastric hemorrhage, dilation, edema, necrosis, and strictures may occur.

Use dry Chemicals, dry sand, or carbon dioxide. If large quantities of combustibles are involved, use water in flooding quantities as spray and fog. Use water spray to knock-down vapors. Cool all affected containers with flooding quantities of water.

Do not use water on material itself.

Reaction with water may generate much heat which will increase the concentration of fumes in the air.

Use non-sparking tools and equipment. Do not get water inside container. Move container from fire area if it can be done without risk. Stay away from the ends of tanks.

Avoid contact with skin, eyes and clothing. Avoid runoff into storm sewers and ditches which lead to water ways. Isolate area. Keep unnecessary and unprotected personnel from entering the contaminated area. If a leak or spill has not ignited, use water spray to disperse the vapors, to protect personnel attempting to stop leak, and to flush spills away from exposures Water spray may be used to cool containers and adjacent surfaces.

Avoid runoff into storm sewers and ditches which lead to water ways.

Use clean non-sparking tools to collect material and place it into loosely covered plastic containers for later disposal. Carefully collect material in containers for disposal.

Materials: clean non-sparking tools, loosely covered plastic containers

Only trained staff with special training and appropriate equipment must handle the product. Good industrial practice in housekeeping and personal hygiene should be followed. Avoid contact with eyes, skin and clothing. Handling should occur in a chemical fume hood. Do not breathe vapor, mist, or gas. Avoid prolonged or repeated exposure. Keep container tightly closed. Avoid contact with heat, sparks and flame. Isolate from incompatible material & conditions. Do not pressurize, cut, weld braze, solder, drill, grid, or expose empty containers to heat, sparks or open flames. Protect against physical damage. Check regularly for spills/leaks.

Store away from incompatible materials and foodstuff. Keep away from heat, sparks, flame and sources of ignition.

Do not eat, drink and smoke in work areas. Wash hands with water & soap after handling the substance; before breaks and after work. Take bath after work. Contaminated clothing and protective equipment should be cleaned before reuse. Good industrial practice in housekeeping and personal hygiene should be followed.

Keep away from heat, sparks, flame and sources of ignition.

Use adequate general or local explosion proof ventilation to keep airborne levels to acceptable levels & other engineering controls to keep employee exposure low.

Wear chemical resistant protective gloves. E.g. Gauntlet type gloves of nitrile rubber or butyl rubber or PVC gloves.

Use safety goggles with side shields and/or a full face shield while handling the material or where splashing is possible. Do not wear contact lenses.

Use self contained, positive pressure breathing apparatus. NIOSH/MSHA approved full face organic respiratory protection is required in the absence of proper environmental control.

Wear chemical resistant apron. Use flame retardant antistatic protective clothing Wear safety shoes for foot protection

Commitments under Community environmental protection legislation: The chemical safety report of this substance will be available after registration

The product is stable in dry atmosphere.

Reacts violently with aluminium, ammonia, potassium, sodium, acetone, dimethyl sulfoxide, water/steam, oxidants, metals, hexafluoroisopropylidene amino lithium, and toluene.

Will react with water, metals and oxidizing agents. Will produce toxic, irritant & hazardous gases.

heat, exposure to moisture, alkalies

alkalies

toxic, irritant & hazardous gases

Spill and waste disposal procedures approved by state and local authorities must be observed.

Do not use metal & base container for storage of waste material for disposal.

Wear suitable protective clothing, gloves, eye/face protection while handling the substance. Avoid exposure of the substance to strong oxidizing agents, alkalies, acids, direct sunlight, water or moisture.

Wear suitable protective clothing, gloves, eye/face protection while handling the substance. Avoid exposure of the substance to strong oxidizing agents, alkalies, acids, direct sunlight, water or moisture.

Wear suitable protective clothing, gloves, eye/face protection while handling the substance. Avoid exposure of the substance to strong oxidizing agents, alkalies, acids, direct sunlight, water or moisture.