Cottonseed Oil

If symptomatic, move to fresh air. Get medical attention if symptoms persist.

Wash skin with soap and water. Get medical attention promptly if symptoms occur after washing.

Symptoms: Prolonged or repeated skin contact may cause drying, cracking, or irritation.

Any material that contacts the eye should be washed out immediately with water. If easy to do, remove contact lenses. Get medical attention promptly if symptoms occur after washing.

Symptoms: Direct contact with eyes may cause temporary irritation.

First aid is normally not required. However, if greater than 1/2 liter (pint) ingested, seek medical attention.

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed such as: Carbon oxides. Rags, steel wool, or waste contaminated with this product may spontaneously catch fire if improperly discarded.

Use standard firefighting procedures and consider the hazards of other involved materials.

Keep unnecessary personnel away. Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid discharge into drains, water courses or onto the ground.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Wipe up with absorbent material. Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand, earth, absorbent material (e.g. cloth, fleece)

Avoid prolonged exposure. Observe good industrial hygiene practices. Proper sanitation with food grade products is essential.

Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). Keep container closed.

Observe good industrial hygiene practices. Proper sanitation with food grade products is essential.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

High surface area exposure to oxygen can result in polymerization and release of heat. No dangerous reaction known under conditions of normal use.

Exposure to heat and contact with sources of ignition. High surface area exposure to oxygen can result in polymerization and release of heat.

Strong oxidizing agents.

No hazardous decomposition products are known, when stored.

Collect and reclaim or dispose in sealed containers at licensed waste disposal site.

Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner.