HyGold L2000

Move to fresh air. Oxygen or artificial respiration if needed. IF exposed or concerned: Get medical advice/attention.

Wash contact areas with soap and water. Remove contaminated clothing. Launder contaminated clothing before reuse. If skin irritation or an allergic skin reaction develops, get medical attention.

Symptoms: Defatting of the skin.

Flush thoroughly with water. If irritation occurs, get medical assistance.

Do NOT induce vomiting. If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Call a poison control centre immediately.

Halon. Dry chemicals. Foam. Carbon dioxide (CO2). Water spray or fog. Do not use water jet as an extinguisher, as this will spread the fire.

Do not use a solid water stream as it may scatter and spread fire.

No unusual fire or explosion hazards noted.

Cool containers exposed to flames with water until well after the fire is out. Firefighters must use standard protective equipment including flame retardant coat, helmet with face shield, gloves, rubber boots, and in enclosed spaces, SCBA. Use pressurised air mask if product is involved in a fire.

Keep unnecessary personnel away. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Prevent further leakage or spillage if safe to do so. Avoid discharge to the aquatic environment.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth, absorbent material (e.g. cloth, fleece)

Do not breathe dust/fume/gas/mist/vapours/spray. Avoid prolonged exposure. All handling to take place in well-ventilated area.

Keep away from heat, sparks and open flame.

Wash hands after handling and before eating. Shower after work. Remove and wash contaminated clothing promptly.

Keep away from heat, sparks and open flame.

Provide adequate ventilation, including appropriate local extraction, to ensure that the defined occupational exposure limit is not exceeded.

Chemical resistant gloves are recommended. If contact with forearms is likely wear gauntlet style gloves. When prolonged or frequent repeated contact occurs, Nitrile gloves may be suitable. (Breakthrough time of > 240 minutes.) For incidental contact/splash protection Neoprene, PVC gloves may be suitable.

Goggles/face shield are recommended.

Under normal conditions, respirator is not normally required. When workers are facing concentrations above the exposure limit they must use appropriate certified respirators.

Chemical/oil resistant clothing is recommended. Launder contaminated clothing before reuse.

Stable.

Strong oxidising agents.

Hazardous polymerisation does not occur.

Avoid temperatures exceeding the flash point.

Strong oxidising agents.

Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons.

Dispose of in accordance with local regulations. Avoid discharge into water courses or onto the ground.

Disposal recommendations are based on material as supplied. Disposal must be in accordance with current applicable laws and regulations, and material characteristics at time of disposal.