Phosphate buffered saline pH 7.4, contains BSA, powder pack

Supply fresh air; consult doctor in case of complaints.

Immediately rinse with water. If skin irritation continues, consult a doctor.

Check for and remove any contact lenses. Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Rinse out mouth and then drink plenty of water. If symptoms persist consult doctor.

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam. Use fire extinguishing methods suitable to surrounding conditions.

Water with full jet

As with most organic solids, fire is possible at elevated temperatures or by contact with an ignition source. Fine dust dispersed in air in sufficient concentrations, and in the presence of an ignition source is a potential dust explosion hazard.

Do not allow to penetrate the ground/soil. Do not allow to enter sewers/ surface or ground water.

Pick up mechanically.

Materials: suitable receptacles

Prevent formation of dust.

Store in cool, dry conditions in well sealed receptacles.

There is a risk of a dust explosion if the following conditions are met: - The substance is present in very finely distributed form (powder, dust). - The substance is whirled up in sufficient quantity in the air. - An ignition source is present (flame, spark, electrostatic discharge, etc.)

No further data; see section 7.

Protective gloves. Use gloves tested and approved under appropriate government standards such as NIOSH (US) or EN374 (EU). The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Safety glasses with side-shields conforming to EN166. Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).

Use suitable respiratory protective device in case of insufficient ventilation.

Protective work clothing

No further relevant information available.

There is a risk of a dust explosion if the following conditions are met: The substance is given in very finely distributed form (powder, dust). The substance is whirled up in sufficient quantity in the air. An ignition source is present (flame, spark, electrostatic discharge, etc.)

The substance is given in very finely distributed form (powder, dust). The substance is whirled up in sufficient quantity in the air. An ignition source is present (flame, spark, electrostatic discharge, etc.)

Strong oxidising agents.

Carbon monoxide and carbon dioxide, Phosphorus oxides (e.g. P.O.), Chlorine compounds, Toxic metal oxide smoke

Minimise waste; Reuse if not contaminated; Recycle, if possible; or Safe disposal (if all else fails). Small amounts may be diluted with plenty of water and washed away. Dispose of bigger amounts in accordance with Local Authority requirements.

Contact waste processors for recycling information.