Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- 1-Chlorobutane
- Product Code
- 6725
- Chemical Name
- 1-Chlorobutane
Regulatory Identifiers
- CAS Number
- 109-69-3 Check regulations →
- EC Number
- 203-696-6 Check regulations →
Identified Uses
For Laboratory, Research or Manufacturing Use.
Uses advised against
Not determined.
Manufacturers & Suppliers
Avantor Performance Materials Poland S.A.
manufacturer
Sowinskiego 11str., 44-101 Gliwice, Poland
48 32 239-20-00
Emergency Contacts
CHEMTREC
(44)-870-8200418
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS02
Hazard Statements
Precautionary Statements
Still copying SDS data manually?Free
You don't have to. NextSDS reads this SDS and adds the information to your library automatically.
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| 1-Chlorobutane EC: 203-696-6 | 109-69-3 | 50 - 100% | Yes |
This substance has workplace exposure limit(s).
Notes
All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume.
First Aid Measures
Emergency procedures for chemical exposure incidents
Move to fresh air.
Get medical attention if symptoms occur. Take off immediately all contaminated clothing. Rinse skin with water [or shower].
Flush thoroughly with water. If irritation occurs, get medical assistance.
Rinse mouth. Get medical attention if symptoms occur. Never give liquid to an unconscious person.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Water Spray, Fog, CO2, Dry Chemical, or Standard Foam
Avoid water in straight hose stream; will scatter and spread fire.
Vapours may cause a flash fire or ignite explosively. Prevent buildup of vapours or gases to explosive concentrations.
No data available.
Firefighter Protection
Firefighters must use standard protective equipment including flame retardant coat, helmet with face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Ventilate closed spaces before entering them. ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Keep upwind.
Dyke far ahead of larger spill for later recovery and disposal.
Do not contaminate water sources or sewer. Prevent further leakage or spillage if safe to do so.
Absorb spill with vermiculite or other inert material, then place in a container for chemical waste.
Materials: vermiculite or other inert material
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Ground and bond container and receiving equipment. Take precautionary measures against static discharges. Use non-sparking tools. Use explosion-proof [electrical/ventilating/lighting] equipment. Use personal protective equipment as required. Wear protective gloves/protective clothing/eye protection/face protection. Remove contaminated clothing and wash the skin thoroughly with soap and water after work. See Section 8 of the SDS for Personal Protective Equipment.
Store in a well-ventilated place. Store in a cool place.
Do not eat, drink or smoke when using the product. Wash at the end of each work shift and before eating, smoking or using the toilet.
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Ground and bond container and receiving equipment. Take precautionary measures against static discharges. Use non-sparking tools.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
No special requirements under ordinary conditions of use and with adequate ventilation. Use explosion-proof ventilation equipment. Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.
Material: Chemical resistant gloves
goggles
If engineering controls do not maintain airborne concentrations below recommended exposure limits (where applicable) or to an acceptable level (in countries where exposure limits have not been established), an approved respirator must be worn.
suitable protective clothing
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Material is stable under normal conditions.
No dangerous reaction known under conditions of normal use.
Hazardous polymerization does not occur.
No special precautions. Heat, sparks, flames.
None known.
Not determined.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
12.1 Toxicity
12.1 Toxicity
Chronic toxicity
No chronic toxicity data available for the product or 1-Chlorobutane.
12.2 Persistence and Degradability
No data on degradability or BOD/COD ratio available.
12.3 Bioaccumulative Potential
Bioaccumulative potential is not known.
12.4 Mobility in Soil:
12.5 Results of PBT and vPvB assessment:
No data available.
12.6 Other Adverse Effects
12.7 Additional Information
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Discharge, treatment, or disposal may be subject to national, state, or local laws.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 1127
- Shipping Name
- CHLOROBUTANES
- Transport Class
- 3
- Packing Group
- II
Regulatory Information
Chemical regulations, safety assessments, and compliance status
Safety, health and environmental regulations/legislation specific for the substance or mixture
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for 1-Chlorobutane?
The signal word is danger.
What is the physical form of 1-Chlorobutane?
1-Chlorobutane is a liquid with colorless color. It has characteristic odor.
What is 1-Chlorobutane used for?
For Laboratory, Research or Manufacturing Use.
What are the hazard statements for 1-Chlorobutane?
This substance has 1 hazard statement:
- H225: Highly flammable liquid and vapour.