Armaflex HT625

When inhaled remove to fresh air and seek medical aid.

Symptoms: Irritating to eyes, respiratory system and skin.

When in contact with the skin, clean with soap and water.

Symptoms: Irritating to eyes, respiratory system and skin.

Remove contact lenses. Rinse eye thoroughly under running water keeping eyelids wide open and protecting the unaffected eye (at least 10 to 15 minutes). Seek medical assistance.

Symptoms: Irritating to eyes, respiratory system and skin.

Do not induce vomiting. Rinse mouth thoroughly with water. Let plenty of water be drunk in small gulps. Call a doctor immediately.

Water spray jet; Carbon dioxide; Dry chemical extinguisher; Foam

High power water jet

In the event of fire, the following can be released: Carbon monoxide (CO); Carbon dioxide (CO2); Hydrogen chloride (HCl)

Refer to protective measures listed in sections 7 and 8. Exclude sources of ignition and ventilate the area. Do not inhale vapours.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

place in container for disposal according to local regulations (see section 13). Do not keep the container sealed.

Provide good ventilation at the work area (local exhaust ventilation, if necessary). Product inherent handling risks must be minimised taking the appropriate measures for protection and preventive actions. The working process should be designed to rule out the release of hazardous substances or skin contact as far it is possible by the state of the art.

Keep under lock and key or accessible only to specialists or people who are authorized. Protect from heat and direct sunlight. Containers which are opened must be carefully closed and kept upright to prevent leakage. Always keep in containers of same material as the original one.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Wash hands before breaks and after work. Do not inhale vapours. Avoid contact with eyes and skin.

Keep away from sources of ignition - refrain from smoking. Take precautionary measures against static charges.

Ensure adequate ventilation, local exhaust at the work station if necessary.

Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of risk of skin contact with the product. Before use, the protective gloves should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves. Appropriate Material: nitrile

Safety glasses with side protection shield (EN 166)

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified. Respirator: A2/P2

Chemical-resistant work clothes. fire-resistant antistatic protective clothing

No data available.

Stable under recommended storage and handling conditions (See section 7).

No data available.

No data available.

Protect from heat and direct sunlight.

strong oxidizing agents

None, if handled according to intended use.

Dispose of according to all applicable regulations upon consultation of the local competent authorities and the disposer in a suitable and authorised disposal facility.

Dispose of according to all applicable regulations upon consultation of the local competent authorities and the disposer in a suitable and authorised disposal facility.