SKD-S2 Aerosol

Bring the person into fresh air and stay with him/her.

Symptoms: Irritation effects: This product contains substances, which may cause irritation upon exposure to skin, eyes or lungs.

Rinse with water. In the event of continued irritation, seek medical assistance. Rinse with water until pain stops then continue to rinse for 30 minutes.

Symptoms: Irritation effects: This product contains substances, which may cause irritation upon exposure to skin, eyes or lungs. Symptoms of neurotoxicity include: loss of appetite, headache, dizziness, ringing in ears, tingling sensations of skin, sensitivity to the cold, cramps, difficulty in concentrating, tiredness, etc. Repeated exposure to solvents can result in the breaking down of the skin's natural fat layer and may result in an increased absorption potential of other hazardous substances at the area of exposure.

Flush eyes immediately with plenty of water or isotonic water (20-30 °C) for at least 5 minutes and continue until irritation stops. Remove contact lenses. Make sure to flush under upper and lower eyelids. If irritation continues, contact a doctor. Continue flushing during transport.

Symptoms: Irritation effects: This product contains substances, which may cause irritation upon exposure to skin, eyes or lungs.

If the person is conscious, rinse the mouth with water and stay with the person. Never give the person anything to drink. In case of malaise, seek medical advice immediately and bring the safety data sheet or label from the product. Do not induce vomiting, unless recommended by the doctor. Have the person lean forward with head down to avoid inhalation of or choking on vomited material.

Alcohol-resistant foam, carbon dioxide, powder, water mist.

Waterjets should not be used, since they can spread the fire.

Extremely flammable aerosol. Pressurised container. In a fire or if heated, a pressure increase will occur and the container may burst. In use may form flammable/explosive vapour-air mixture. Fire will result in dense smoke. Exposure to combustion products may harm your health.

Closed containers, which are exposed to fire, should be cooled with water.

Storages not yet ignited must be cooled by water mist. Remove flammable materials if conditions allow it.

Avoid discharge to lakes, streams, sewers, etc.

Wherever possible cleaning should be performed with normal cleaning agents. Avoid use of solvents.

Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. The product should be tested for peroxides before distillation or evaporation and tested for peroxide formation or discarded after 1 year. Peroxide formation may be present anywhere in the container, including the sides, bottom, exterior and threaded cap. Peroxide formation in ppm concentrations may not be visually observable and must be identified through the use of appropriate testing procedures. If any of the following conditions exist, the material may be explosively unstable and will require stabilization prior to use: 1. Material appears to be degraded and or contaminated. 2. Material appears to be discolored. 3. Deterioration or distortion of storage container. 4. Thermal shock (sunlight). 5. Age of material exceeds recommended storage time. Avoid contact during pregnancy and while nursing.

Store in tightly closed containers and store protected from moisture and light. Must be stored in a cool and well-ventilated area, away from possible sources of ignition.

Smoking, drinking and consumption of food is not allowed in the work area.

Do not spray on an open flame or other ignition source.

Apply standard precautions during use of the product. Avoid inhalation of gas or dust.

Material: Nitrile, Glove thickness: 0,38 mm, Breakthrough time: >480 min, Standards: EN374-2, EN374-3, EN388

Type: Safety glasses, Standards: EN166

In case of inadequate ventilation wear respiratory protection. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator.

Dedicated work clothing should be worn.

No specific requirements.

The product is stable under the conditions, noted in section 7 "Handling and storage".

No data available.

None known.

Avoid static electricity. Do not expose to any forms of heat (e.g. solar radiation). May lead to excess pressure.

Strong acids, strong bases, strong oxidizing agents, and strong reducing agents.

Under normal conditions of storage and use, hazardous decomposition products should not be produced