NextSDS Logo
Safety Data Sheet EN

SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE

How compliant is your chemical safety?

Free 2-minute compliance assessment

Check Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE
Product Code
680071befüllt

Regulatory Identifiers

CAS Number
N/A

Identified Uses

painting

Uses advised against

No further relevant information available.

Manufacturers & Suppliers

P

Peter Kwasny GmbH

manufacturer

Heilbronner Str. 96, D-74831 Gundelsheim

0049-(0)6269-95-20

Emergency Contacts

Emergency Contact

+49 6269 95 20

National Poisons Information Service, Birmingham

844 892 0111

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1 H222
Aerosol Cat. 1 H229
Eye Irrit. Cat. 2
STOT SE Cat. 3 H336
Aquatic Chronic Cat. 3 H412

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

Hazard Statements

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
H412 Harmful to aquatic life with long lasting effects.

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P103 Read carefully and follow all instructions.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P261 Avoid breathing vapours/spray.
P271 Use only outdoors or in a well-ventilated area.
P273 Avoid release to the environment.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P312 Call a POISON CENTER/doctor if you feel unwell.
P337+P313 If eye irritation persists: Get medical advice/attention.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 ℃/122 ºF.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Mixture of substances listed below with nonhazardous additions.

Chemical Name CAS Number Concentration Hazardous
dimetiletere EC: 204-065-8 115-10-6 25 - 50% Yes
2-Propanon EC: 200-662-2 67-64-1 25 - 50% Yes
2, 3-epoxypropylneodecanoaat EC: 203-603-9 108-65-6 5 - 10% Yes
xyleen 1,2,4-trimethylbenzeen 2-methoxy-1-methylethylacetaat EC: 215-535-7 1330-20-7 2.5 - 5% Yes
N-BUTYLACETATE EC: 204-658-1 123-86-4 1 - 2.5% Yes
a-[3-[3-(2H-benzotriazol-2-yl)derivatives EC: 400-830-7 --- 0.25 - 1% Yes
2-Ethylhexansäure, Zirconiumsalz EC: 245-018-1 22464-99-9 1% Yes
Bis(1,2,2,6,6-pentamethyl-4-piperidyl) sebacate EC: 255-437-1 41556-26-7 0.25 - 1% Yes
isobutyl methacrylate EC: 202-613-0 97-86-9 0.1 - 1% Yes
2-Ethylhexansäure, Mangansalz EC: 240-085-3 15956-58-8 0.25% Yes
methyl 1,2,2,6,6-pentamethyl-4-piperidylsebacate EC: 280-060-4 82919-37-7 0.1 - 0.25% Yes

For the wording of the listed hazard phrases refer to section 16.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Supply fresh air; consult doctor in case of complaints.

Eye contact

Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Ingestion

If symptoms persist consult doctor.

Related Substances

Similar chemicals with comparable safety profiles

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

No further data; see item 7.

Hands

Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves Nitrile rubber, NBR. Gloves must be changed after every contamination. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact of a maximum of 15 minutes gloves made of the following materials are suitable: butyl rubber, 0.7mm.

Eyes

Safety glasses. Tightly sealed goggles.

Respiratory

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Half mask with combination filter, class A1P2 minimum, or breathing mask with outer air supply.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Molecular Weight
---
Decomposition Temperature
Not determined.
Kinematic Viscosity
Not determined.
Form
Aerosol
Appearance
---
Physical State
Aerosol
Voc Content
81.15%
Physical State Data
aerosol
Bulk Density
---
Solubility
---
Dynamic Viscosity
Not determined.
Ph
Not determined.
State Under Standard Conditions
---
Relative Density
Not determined.
Freezing Point
Undetermined.
Solubility In Fat
---
Boiling Point
- 24.9 ℃
Upper Explosive Limit
18.6 Vol %
Metal Corrosion
---
Flash Point
-42 °℃ Without propellant gas.
Solubility In Water
Fully miscible.
Odor Threshold
Not determined.
Density
0.83762 g/cm3
Explosive Limits
---
Crystallisation Point
---
Lower Explosive Limit
2.6 Vol %
Evaporation Rate
Not applicable.
Odor
Characteristic
Properties Status
---
Colour Intensity
---
Flammability
Not applicable.
Relative Evaporation Rate
---
Vapor Density
Not determined.
Partition Coefficient
Not determined.
Melting Point
Undetermined.
Vapor Pressure
3,400 hPa
Solidification Point
---
Softening Point
---
Auto Ignition Temperature
Product is not selfigniting.
Colour
Orange
Cloud Point
---
14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1950
Shipping Name
AEROSOLS, flammable
Transport Class
2.1
Packing Group
Void not classified
ADR

Warning: Gases.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE?

The signal word is danger.

What is the physical form of SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE?

SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE is a aerosol with orange color. It has characteristic odor.

What is SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE used for?

painting

What are the hazard statements for SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE?

This substance has 5 hazard statements:

  • H222: Extremely flammable aerosol.
  • H229: Pressurised container: May burst if heated.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.
  • H412: Harmful to aquatic life with long lasting effects.

What is the melting point of SprayMax 1K Fill-in 680071 befüllt mit 100ml des Lackmaterials 1K TOUCH UP SAL DOOSAN KAIROS ORANGE?

The melting point is Undetermined. and the boiling point is - 24.9 ℃.

Compliance Scan

Free compliance check