Elevate EPDM Solvent Free Bonding Adhesive

Move to fresh air. Call a physician if symptoms develop or persist.

Remove contaminated clothing immediately and wash skin with soap and water. In case of eczema or other skin disorders: Seek medical attention and take along these instructions.

Symptoms: May cause an allergic skin reaction. Dermatitis. Rash.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention immediately.

Symptoms: Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Permanent eye damage including blindness could result.

Rinse mouth. Get medical attention if symptoms occur.

Foam. Dry chemical powder. Carbon dioxide (CO2). Water fog.

Do not use water jet as an extinguisher, as this will spread the fire.

May react with water liberating a small amount of methanol. During fire, gases hazardous to health may be formed such as: Carbon oxides (COx). Nitrogen Oxides (NOx). Silicon oxides. Formaldehyde.

Move containers from fire area if you can do so without risk. Use water spray to keep fire-exposed containers cool.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Avoid breathing mist/vapors. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into drains, water courses or onto the ground.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Following product recovery, flush area with water.

Materials: absorbent material (e.g. cloth, fleece), vermiculite, dry sand or earth

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not get this material in contact with eyes. Avoid breathing mist/vapors. Avoid contact with skin and clothing. Avoid prolonged exposure. Pregnant or breastfeeding women must not handle this product. Should be handled in closed systems, if possible. Provide adequate ventilation. Wear appropriate personal protective equipment. Avoid release to the environment. Observe good industrial hygiene practices.

Store locked up. Store in tightly closed container. Store away from incompatible materials (see Section 10 of the SDS).

Observe good industrial hygiene practices.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station.

Wear appropriate chemical resistant gloves. Examples of preferred glove barrier materials include: Nitrile. Suitable gloves can be recommended by the glove supplier.

Wear safety glasses with side shields (or goggles).

If engineering controls do not maintain airborne concentrations below recommended exposure limits (where applicable) or to an acceptable level (in countries where exposure limits have not been established), an approved respirator must be worn. Chemical respirator with organic vapor cartridge and full facepiece. Appropriate respirator selection should be made by a qualified professional.

Wear appropriate chemical resistant clothing. Use of an impervious apron is recommended.

Material is stable under normal conditions.

May react with water liberating a small amount of methanol.

No dangerous reaction known under conditions of normal use.

Contact with incompatible materials.

Acids. Strong oxidizing agents. Fluorine.

Thermal decomposition or combustion may produce: Carbon oxides. Silicon oxides. Nitrogen oxides. Formaldehyde.

Collect and reclaim or dispose in sealed containers at licensed waste disposal site.

Dispose of contents/container in accordance with local/regional/national/international regulations.