KRONES celerol FL 7216

Remove to fresh air, keep patient warm and at rest. If breathing is irregular or stopped, administer artificial respiration. In case of persisting adverse effects consult a physician.

When in contact with the skin, clean with soap and water. Consult a doctor if skin irritation persists.

Remove contact lenses. Rinse eye thoroughly under running water keeping eyelids wide open and protecting the unaffected eye (at least 10 to 15 minutes). Get medical attention if pain still persists.

Rinse mouth thoroughly with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention if pain still persists.

Water spray jet; Alcohol-resistant foam; Dry chemical extinguisher; Carbon dioxide

High power water jet

Carbon monoxide and carbon dioxide

Remove persons to safety.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

Contain and collect spillage with non-combustible absorbent materials.

Materials: sand, earth, vermiculite, diatomaceous earth

Risks inherent to handling the product must be minimised by applying the appropriate protective and preventive measures. Working processes should - so far as possible, according to the state of the art - be designed to rule out bodily contact or the release of hazardous substances.

Keep container tightly closed and dry in a cool, well-ventilated place.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Wash hands before breaks and after work. Do not inhale vapours.

Ensure adequate ventilation, local exhaust at the work station if necessary.

In case of intensive contact, wear protective gloves (EN 374). Before use, the protective gloves should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves. Appropriate Material: nitrile rubber

Safety glasses (EN 166)

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified. Respirator: A-P

Chemical-resistant work clothes.

No data available.

Stable under recommended storage and handling conditions (See section 7).

No data available.

Dangerous reactions are not to be expected when handling product according to its intended use.

No data available.

No data available.

No data available.

Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in agreement with the regional waste disposal company.

Disposal of the product should be carried out in accordance with all applicable regulations following consultation with the responsible local authority and the disposal company in an authorised and suitable disposal facility.