3M™ Bornitrid Spray TG

Ensure supply of fresh air. In case of respiratory arrest induce breathing with a respiratory device. Seek medical advice.

Wash off with soap and water. With frostbite sterile cover. Consult a doctor if skin irritation persists.

In case of contact with the eyes, rinse immediately for at least 15 minutes with plenty of water. Seek medical assistance.

Call in a physician immediately and show him the Safety Data Sheet.

Water mist; Alcohol-resistant foam; Carbon dioxide; Extinguishing powder; Sand

Full water jet; Water spray jet

May explode if exposed to heat.

Heat causes increase in pressure and risk of bursting. In case of fire remove tanks from danger area. Cool endangered containers with water in case of fire.

Refer to protective measures listed in sections 7 and 8. Avoid contact with skin, eyes and clothing. Do not inhale vapours. Ensure adequate ventilation. Keep away sources of ignition.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil. Suppress gases/vapours/mists with water spray jet.

Take up with absorbent material. Take up mechanically and send for disposal.

Materials: absorbent material (e.g., sand, diatomaceous earth, universal binder)

Do not open sprays violently and do not keep above 122°F. Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limits. Do not use on oxygen valves.

Keep only in the original container in a cool, well ventilated place. Protect from sun. Protect from warmth.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Avoid contact with eyes and skin. Do not inhale vapours. Wash hands before breaks and after work. Use barrier skin cream.

Vapors are heavier than air and may spread along floors. Vapors may form explosive mixtures with air.

No data available.

Appropriate Material: butyl rubber. The glove(s) listed below may provide protection against permeation. Gloves of other chemically resistant materials may not provide adequate protection. Before use, the protective glove should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves.

Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133.

If workplace exposure limits are exceeded, a respirations protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified. A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements must be followed whenever workplace conditions warrant a respirator's use.

Normal chemical work clothing.

No data available.

No data available.

No data available.

Hazardous polymerization will not occur under normal conditions.

Heat, open flames and other sources of ignition.

Alkali metals; Earth alkali metals; oxygen; Oxidizing agents

None, if handled according to intended use.

Dispose in accordance with federal, state and local regulations.