Optigear BM 460

If inhaled, remove to fresh air. Get medical attention if symptoms appear.

Immediately wash exposed skin with soap and water. Remove contaminated clothing and shoes. Wash clothing before reuse. Clean shoes thoroughly before reuse. Obtain medical attention immediately.

In case of contact, immediately flush eyes with a copious amount of water for at least 15 minutes. Get medical attention if irritation occurs.

Do NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. If large quantities of this material are swallowed, call a physician immediately.

In case of fire, use water fog, foam, dry chemical or carbon dioxide extinguisher or spray.

Do not use water jet.

This material is not explosive as defined by established regulatory criteria.

None identified.

Immediately contact emergency personnel. Keep unnecessary personnel away. Use suitable protective equipment (See Section: "Exposure controls/personal protection"). Follow all fire fighting procedures (See Section: "Fire-fighting measures").

For small spills add absorbent (soil may be used in the absence of other suitable materials) scoop up material and place in a sealed, liquid-proof container for disposal.

For large spills dike spilled material or otherwise contain material to ensure runoff does not reach a waterway. Place spilled material in an appropriate container for disposal.

Avoid contact of spill material with soil and prevent runoff entering surface waterways.

scoop up material and place in a sealed, liquid-proof container for disposal.

Do not get on skin or clothing. Avoid contact of spilled material and runoff with soil and surface waterways. Wash thoroughly after handling.

Keep container tightly closed. Keep container in a cool, well-ventilated area.

Wash thoroughly after handling.

Provide exhaust ventilation or other engineering controls to keep the relevant airborne concentrations below their respective occupational exposure limits.

Wear suitable gloves. Chemical resistant gloves. Recommended: Nitrile gloves. The correct choice of protective gloves depends upon the chemicals being handled, the conditions of work and use, and the condition of the gloves (even the best chemically resistant glove will break down after repeated chemical exposures). Most gloves provide only a short time of protection before they must be discarded and replaced. Because specific work environments and material handling practices vary, safety procedures should be developed for each intended application. Gloves should therefore be chosen in consultation with the supplier/manufacturer and with a full assessment of the working conditions.

Safety glasses with side shields.

None required; however, use of adequate ventilation is good industrial practice.

Do not get on skin or clothing. Wear suitable protective clothing.

Will not occur.

oxidizing materials

carbon oxides (CO, CO₂) (carbon monoxide, carbon dioxide), nitrogen oxides (NO, NO 2 etc.), sulphur oxides (SO₂, SO₃, etc.), phosphates. Some metallic oxides.

Use only approved transporters, recyclers, treatment, storage or disposal facilities.

Dispose of in accordance with all applicable local and national regulations.