Ringer's solution tablets

Remove to fresh air. If breathing is difficult, give oxygen. Get medical attention immediately if symptoms occur.

Wash off immediately with plenty of water for at least 15 minutes. Get medical attention immediately if symptoms occur.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Do NOT induce vomiting. Get medical attention.

Water spray, carbon dioxide (CO2), dry chemical, alcohol-resistant foam.

No information available.

Thermal decomposition can lead to release of irritating gases and vapors.

Ensure adequate ventilation. Use personal protective equipment as required.

Should not be released into the environment.

Sweep up and shovel into suitable containers for disposal.

Wear personal protective equipment/face protection. Ensure adequate ventilation. Avoid contact with skin, eyes or clothing. Avoid ingestion and inhalation. Avoid dust formation.

Keep containers tightly closed in a dry, cool and well-ventilated place.

Handle in accordance with good industrial hygiene and safety practice. Keep away from food, drink and animal feeding stuffs. Do not eat, drink or smoke when using this product. Remove and wash contaminated clothing and gloves, including the inside, before re-use. Wash hands before breaks and after work.

Ensure that eyewash stations and safety showers are close to the workstation location. Ensure adequate ventilation, especially in confined areas. Wherever possible, engineering control measures such as the isolation or enclosure of the process, the introduction of process or equipment changes to minimise release or contact, and the use of properly designed ventilation systems, should be adopted to control hazardous materials at source

Protective gloves. Glove material: Disposable gloves. Breakthrough time: See manufacturers recommendations. EU standard: EN 374 (minimum requirement). Inspect gloves before use. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Ensure gloves are suitable for the task: Chemical compatability, Dexterity, Operational conditions, User susceptibility, e.g., sensitisation effects, also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. Remove gloves with care avoiding skin contamination.

Wear safety glasses with side shields (or goggles) (European standard - EN 166)

Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. To protect the wearer, respiratory protective equipment must be the correct fit and be used and maintained properly. In case of insufficient ventilation, wear suitable respiratory equipment. For small scale/Laboratory use: Use a NIOSH/MSHA or European Standard EN 149:2001 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. When RPE is used a face piece Fit Test should be conducted.

Wear appropriate protective gloves and clothing to prevent skin exposure.

No information available.

Stable under normal conditions.

None known, based on information available

Hazardous polymerization does not occur. None under normal processing.

Incompatible products. Excess heat. Avoid dust formation.

Strong oxidizing agents.

Carbon monoxide (CO). Carbon dioxide (CO₂). Sodium oxides.

Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste.

Consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification.