NextSDS Logo
Safety Data Sheet EN

DEVELON ULTRA ENGINE POWER 10W-30 CK-4

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
DEVELON ULTRA ENGINE POWER 10W-30 CK-4
Product Code
74672

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Engine oil.

Uses advised against

This product should not be used for other purposes than those specified without the advice of an expert.

Manufacturers & Suppliers

P

PETRONAS LUBRICANTS ITALY S.P.A.

manufacturer

Via Santena 1, 10029 Villastellone (Torino)

+39.01196131

Emergency Contacts

Emergency Answer Service

+44 1235 239670

24h/7d

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified

GHS Pictograms

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Severely refined mineral and/or synthetic oils, additives.

Chemical Name CAS Number Concentration Hazardous
Distillates, petroleum, hydrotreated heavy paraffinic EC: 265-157-1 64742-54-7 20 - 30% Yes
reaction mass of isomers of C7-9-alkyl 3-(3,5-di-trans-butyl-4-hydroxyphenyl)propioate EC: 406-040-9 125643-61-0 2.5 - 3% Yes
Zinc bis[O-(6-methylheptyl)] bis[O-(sec-butyl)] bis(dithiophosphate) EC: 298-577-9 93819-94-4 1 - 1.5% Yes
Distillates (petroleum), solvent-dewaxed light paraffinic EC: 265-159-2 64742-56-9 1 - 1.5% Yes
Distillates (petroleum), solvent-dewaxed heavy paraffinic EC: 265-169-7 64742-65-0 1 - 1.5% Yes
Paraffin oils, petroleum, catalytic dewaxed heavy EC: 265-174-4 64742-70-7 1 - 1.5% Yes
Molibdenum polysulphide long chain alkyl dithiocarbamate complex EC: 457-320-2 --- 0.1 - 0.25% Yes
Not classified oils --- 50 - 70% No

(*)DECLL The mineral base oils contained in this product are severely refined and contain less than 3% DMSO extract according to IP 346 method, and are therefore not classified as carcinogen according to Regulation (EC) No 1272/2008, note L. The harmonised classification as a carcinogen applies unless it can be shown that the substance contains less than 3 % of dimethyl sulphoxide extract as measured by IP 346 (“Determination of polycyclic aromatics in unused lubricating base oils and asphaltene free petroleum fractions – Dimethyl sulphoxide extraction refractive index method” Institute of Petroleum, London), in which case a classification in accordance with Title II of this Regulation shall be performed also for that hazard class.

Notes

(*)DECLL The mineral base oils contained in this product are severely refined and contain less than 3% DMSO extract according to IP 346 method, and are therefore not classified as carcinogen according to Regulation (EC) No 1272/2008, note L.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Expose affected person to fresh air and obtain medical attention if necessary.

Skin contact

Remove contaminated clothes and shoes and rinse thoroughly with plenty of water and soap.

Eye contact

Rinse thoroughly with plenty of water for at least 10 minutes keeping eyelids open. Remove contact lenses if this can be done easily. Obtain medical attention in case of development and persistence of pain and redness. In case of contact with hot product, rinse thoroughly with plenty of water to dissipate heat. Obtain immediate medical attention to assess eye conditions and the correct treatment to be practiced.

Symptoms: pain and redness

Ingestion

Do not induce vomiting to avoid aspiration into the respiratory tracts. Wash out thoroughly the mouth with water. Obtain immediate medical attention.

Immediate Medical Attention

Obtain immediate medical attention in case of development and persistence of pain and redness (eyes), in case of contact with hot product (eyes), and in case of ingestion.

Medical Treatment

Refer to section 4.1.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

foam, carbon dioxide, dry chemical powder, water mist, water.

Unsuitable media

High pressure water jet. None in particular.

Specific hazards

Fire can form harmful compounds. Burning produces heavy smoke.

Instructions

Cool down with water the containers not involved in fire to avoid their possible explosion. Use water jet only to cool down surfaces exposed to fire. Move undamaged containers from immediate hazard area if it can be done safely.

Firefighter Protection

Use suitable breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Avoid ingestion of product. Avoid contact with skin and eyes by wearing appropriate protective clothing. Avoid to breathe fumes and aerosols. Surfaces on which the product has been spilled may become slippery. Wear personal protection equipment.

Small spill

Contain small spills with absorbent material.

Large spill

In case of large spills dike, absorb and shovel up into suitable containers for disposal.

Environmental

Do not allow to enter into soil/subsoil. Do not allow to enter into surface water or drains. Retain contaminated washing water and dispose it.

Cleanup methods

shovel up into suitable containers for disposal. Put dirty material in suitable container.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid ingestion. Avoid frequent and prolonged skin contact and contact with eyes. Provide adequate ventilation to avoid mist or aereosol. Don't smoke or use spare flames; avoid contact with spark or other sources of ignition. Don't work near open container to avoid high concentration of vapours. Don't eat or drink during use.

Storage

Store under cover in the original container securely closed away from heat and sources of ignition. Do not store in the open air. Assure a correct ventilation of premises and the control of possible leak. Keep out of flame or spark and avoid the accumulation of electrostatic charges. Keep out of reach of children and away from food and drink.

Hygiene

Don't eat or drink during use.

Fire prevention

Don't smoke or use spare flames; avoid contact with spark or other sources of ignition. Don't work near open container to avoid high concentration of vapours.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Avoid production and diffusion of mist and aerosol with utilization of localized ventilation/aspiration or other required precautions.

Hands

Wear suitable gloves (i.e. neoprene, nitrile). Gloves should be changed when they show wear. The kind of gloves and the term of use must be decided from employer with regard to processing and to allow for DPI legislation and glove producer's indications. Wear gloves only with clean hands.

Eyes

Chemical goggles and face shield in case of oil splashes.

Respiratory

None required under normal conditions of use. Use approved full face respirator with organic vapour filter cartridge if the recommended exposure limits are exceeded.

Skin/Body

Wear suitable protective clothing (for further information, refer to CEN-EN 14605); change it immediately in case of large contamination and wash it before subsequent use.

Environmental

Adopt all required precaution to avoid product immission in environment (e.g., blasting systems, catch basins, ...). Refer to technical precautions and also to sections 6.2, 6.3, 7.2, 12 and 13.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Colour
AMBER
Vapor Pressure
N.A.
Flash Point
208 °C (406 °F)
Odor Threshold
NOT RELEVANT
Solubility In Water
IMMISCIBLE
Lower Explosive Limit
N.A.
Density
0.87 G/CM3
Form
---
Bulk Density
---
Solubility In Fat
N.A.
Kinematic Viscosity
AT 100°C: N.A., AT 40°C: 81.87 CST
Upper Explosive Limit
N.A.
Partition Coefficient
N.A.
Auto Ignition Temperature
N.A.
Ph
N.A.
Appearance
VISCOUS AMBER
Boiling Point
>300 °C (572 °F)
Relative Density
---
Odor
NOT RELEVANT
Molecular Weight
---
Evaporation Rate
---
Freezing Point
N.A.
State Under Standard Conditions
---
Cloud Point
---
Solidification Point
---
Colour Intensity
---
Voc Content
N.A.
Flammability
N.A.
Metal Corrosion
---
Dynamic Viscosity
---
Crystallisation Point
---
Physical State
LIQUID
Softening Point
---
Relative Evaporation Rate
---
Vapor Density
N.A.
Explosive Limits
---
Solubility
---
Melting Point
N.A.
Decomposition Temperature
N.A.
Properties Status
---
Physical State Data
liquid
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

The product is stable under normal conditions of use.

Reactivity

Read carefully all information provided in other sections of heading 10.

Hazardous reactions

Not expected under normal conditions of use.

Avoid

This product must be kept far from heat sources. In any case, avoid exposing product to temperatures above the flash point.

Incompatible

Strong oxidizing agents, hard acids and bases.

Decomposition

Oxides of carbon, compounds of sulphur, phosphorus, nitrogen and hydrogen sulfide.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

TOXICITY

Eco-Toxicological Information: This product is not classified dangerous for the environment. List of Eco-Toxicological properties of the components COMPONENT IDENT. NUMB. ECOTOX DATA Distillates, petroleum, hydrotreated heavy paraffinic (649-467-00-8) CAS: 64742-54-7 - EINECS: 265-157-1 a) Aquatic acute toxicity : LC50 Fish Pimephales promelas > 100 mg/L 96h b) Aquatic chronic toxicity : NOELR Oncorhynchus mykiss >= 1000 mg/L b) Aquatic chronic toxicity : NOEC Fish > 1 mg/L b) Aquatic chronic toxicity : NOEC Daphnia > 1 mg/L - water flea reaction mass of isomers of C7-9-alkyl 3-(3,5-di-trans-butyl-4-hydroxyphenyl)propioate CAS: 125643-61-0 - EINECS: 406-040-9 - INDEX: 607-530-00-7 a) Aquatic acute toxicity : LC50 Fish Danio Rerio > 74 mg/L 96h Zinc bis[O-(6-methylheptyl)] bis[O-(sec-butyl)] bis(dithiophosphate) CAS: 93819-94-4 - EINECS: 298-577-9 b) Aquatic chronic toxicity : LC50 Fish Rainbow trout = 4.5 mg/L 96h b) Aquatic chronic toxicity : EL50 Daphnia Water flea = 5.4 mg/L 48h b) Aquatic chronic toxicity : EC50 Algae Green algae = 2.1 mg/L 96h No endocrine disruptor substances present in concentration >= 0.1%

This product is not classified dangerous for the environment. Ecological toxicity data for several components are provided, including acute and chronic aquatic toxicity for fish, daphnia, and algae. No endocrine disruptor substances are present in concentrations >= 0.1%.

PERSISTENCE AND DEGRADABILITY

Data on biodegradability of product are not available.

Data on biodegradability of the product are not available.

BIOACCUMULATIVE POTENTIAL

Not available.

Information on bioaccumulative potential is not available.

MOBILITY IN SOIL

As the dispersion in the environment may result in contamination of environmental matrix (soil, subsoil, surface water and groundwater), do not release in the environment.

Dispersion in the environment may lead to contamination of soil, subsoil, surface water, and groundwater; therefore, the product should not be released into the environment.

RESULTS OF PBT AND VPVB ASSESSMENT

vPvB substances: None - PBT substances: None

No vPvB (very Persistent and very Bioaccumulative) or PBT (Persistent, Bioaccumulative, and Toxic) substances are present.

ENDOCRINE DISRUPTING PROPERTIES

No endocrine disruptors present at concentrations >= 0.1%

No endocrine disruptors are present at concentrations equal to or greater than 0.1%.

OTHER ADVERSE EFFECTS

No effect known.

No other adverse effects are known.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Treatment

Dispose in accordance with local or national regulations via authorised person/licensed waste disposal contractor.

Disposal

Recover if possible. In so doing, comply with the local and national regulations currently in force.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Regulation (EC) No 1272/2008, Regulation (EC) No 1907/2006, and various EU Directives regarding worker safety, chemical agent risks, waste, and environmental protection.

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for DEVELON ULTRA ENGINE POWER 10W-30 CK-4?

The signal word is no signal word.

What is the physical form of DEVELON ULTRA ENGINE POWER 10W-30 CK-4?

DEVELON ULTRA ENGINE POWER 10W-30 CK-4 is a liquid appearing as viscous amber with amber color. It has not relevant odor.

What is DEVELON ULTRA ENGINE POWER 10W-30 CK-4 used for?

Engine oil.

What is the melting point of DEVELON ULTRA ENGINE POWER 10W-30 CK-4?

The melting point is N.A. and the boiling point is >300 °C (572 °F).

Compliance Scanner

Scan your compliance