NextSDS Logo
Safety Data Sheet EN

DEVELON AXLE/TRANSMISSION 10W-30

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
DEVELON AXLE/TRANSMISSION 10W-30
Product Code
76914

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Lubricant for transmission system.

Uses advised against

This product should not be used for other purposes than those specified without the advice of an expert.

Manufacturers & Suppliers

P

PETRONAS LUBRICANTS ITALY S.P.A.

manufacturer

Via Santena 1, 10029 Villastellone (Torino)

+39.01196131

Emergency Contacts

Emergency Answer Service

+44 1235 239670

24h/7d

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified

GHS Pictograms

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Hazardous components within the meaning of the CLP regulation and related classification: Not classified oils (90.0-100.0 %). The mineral base oils contained in this product are severely refined and contain less than 3% DMSO extract according to IP 346 method, and are therefore not classified as carcinogen according to Regulation (EC) No 1272/2008, note L.

Chemical Name CAS Number Concentration Hazardous
Distillates (petroleum), hydrotreated light EC: 265-158-7 64742-55-8 1.5 - 2% Yes
Zinc bis[O,O-bis(2-ethylhexyl)] bis(dithiophosphate) EC: 224-235-5 4259-15-8 1.5 - 2% Yes
Benzenesulfonic acid, propenated, calcium salt, overbased 68610-84-4 0.5 - 0.95% Yes
Not classified oils --- 90 - 100% No

(*)DECLL The mineral base oils contained in this product are severely refined and contain less than 3% DMSO extract according to IP 346 method, and are therefore not classified as carcinogen according to Regulation (EC) No 1272/2008, note L.

Notes

The harmonised classification as a carcinogen applies unless it can be shown that the substance contains less than 3 % of dimethyl sulphoxide extract as measured by IP 346 (“Determination of polycyclic aromatics in unused lubricating base oils and asphaltene free petroleum fractions – Dimethyl sulphoxide extraction refractive index method” Institute of Petroleum, London), in which case a classification in accordance with Title II of this Regulation shall be performed also for that hazard class.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Expose affected person to fresh air and obtain medical attention if necessary.

Skin contact

Remove contaminated clothes and shoes and rinse thoroughly with plenty of water and soap.

Eye contact

Rinse thoroughly with plenty of water for at least 10 minutes keeping eyelids open. Remove contact lenses if this can be done easily. Obtain medical attention in case of development and persistence of pain and redness. In case of contact with hot product, rinse thoroughly with plenty of water to dissipate heat. Obtain immediate medical attention to assess eye conditions and the correct treatment to be practiced.

Symptoms: pain and redness

Ingestion

Do not induce vomiting to avoid aspiration into the respiratory tracts. Wash out thoroughly the mouth with water. Obtain immediate medical attention.

Immediate Medical Attention

Obtain immediate medical attention in case of ingestion or contact with hot product.

Medical Treatment

Refer to section 4.1.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Use foam, carbon dioxide, dry chemical powder and water mist. Suitable extinguishing media: Water, Carbon dioxide (CO2).

Unsuitable media

Avoid high pressure water jet. None in particular.

Specific hazards

Don't breathe combustion fumes: fire can form harmful compounds. Do not inhale explosion and combustion gases. Burning produces heavy smoke.

Instructions

Cool down with water the containers don't get involved in fire to avoid their possible explosion. Move undamaged containers from immediate hazard area if it can be done safely.

Firefighter Protection

Use suitable breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Avoid ingestion of product. Avoid contact with skin and eyes by wearing appropriate protective clothing. Avoid to breathe fumes and aerosols. Surfaces on which the product has been spilled may become slippery. Wear personal protection equipment.

Small spill

Contain small spills with absorbent material.

Large spill

In case of large spills dike, absorb and shovel up into suitable containers for disposal.

Environmental

Do not allow to enter into soil/subsoil. Do not allow to enter into surface water or drains. Retain contaminated washing water and dispose it.

Cleanup methods

shovel up into suitable containers for disposal. Put dirty material in suitable container.

Materials: suitable containers

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid ingestion. Avoid frequent and prolonged skin contact and contact with eyes. Provide adequate ventilation to avoid mist or aerosol. Don't smoke or use spare flames; avoid contact with spark or other sources of ignition. Don't work near open container to avoid high concentration of vapours. Don't eat or drink during use.

Storage

Store under cover in the original container securely closed away from heat and sources of ignition. Do not store in the open air. Assure a correct ventilation of premises and the control of possible leak. Keep out of flame or spark and avoid the accumulation of electrostatic charges. Keep out of reach of children and away from food and drink.

Hygiene

Don't eat or drink during use.

Fire prevention

Don't smoke or use spare flames; avoid contact with spark or other sources of ignition.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Avoid production and diffusion of mist and aerosol with utilization of localized ventilation/aspiration or other required precautions.

Hands

Wear suitable gloves (i.e. neoprene, nitrile). Gloves should be changed when they show wear. The kind of gloves and the term of use must be decided from employer with regard to processing and to allow for DPI legislation and glove producer's indications. Wear gloves only with clean hands.

Eyes

Chemical goggles and face shield in case of oil splashes.

Respiratory

None required under normal conditions of use. Use approved full face respirator with organic vapour filter cartridge if the recommended exposure limits are exceeded.

Skin/Body

Wear suitable protective clothing (for further information, refer to CEN-EN 14605); change it immediately in case of large contamination and wash it before subsequent use.

Environmental

Adopt all required precaution to avoid product immission in environment (e.g., blasting systems, catch basins, ...). Refer to technical precautions and also to sections 6.2, 6.3, 7.2, 12 and 13.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Explosive Limits
---
Evaporation Rate
---
Solubility In Water
IMMISCIBLE
Physical State
LIQUID
Lower Explosive Limit
N.A.
Solubility
---
Kinematic Viscosity
61.48 CST
Voc Content
N.A.
Molecular Weight
---
Dynamic Viscosity
---
Upper Explosive Limit
N.A.
Appearance
VISCOUS AMBER
Softening Point
---
Metal Corrosion
---
Partition Coefficient
N.A.
Form
VISCOUS
Solubility In Fat
N.A.
Auto Ignition Temperature
N.A.
Ph
N.A.
State Under Standard Conditions
---
Flash Point
212 °C (414 °F)
Freezing Point
N.A.
Vapor Pressure
N.A.
Cloud Point
---
Flammability
N.A.
Physical State Data
liquid
Colour
AMBER
Odor
NOT RELEVANT
Density
0.87 G/CM3
Odor Threshold
NOT RELEVANT
Boiling Point
300 °C (572 °F)
Crystallisation Point
---
Decomposition Temperature
N.A.
Relative Evaporation Rate
---
Bulk Density
---
Colour Intensity
---
Relative Density
---
Properties Status
---
Solidification Point
---
Melting Point
N.A.
Vapor Density
N.A.
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

The product is stable under normal conditions of use.

Hazardous reactions

Not expected under normal conditions of use.

Avoid

This product must be kept far from heat sources. In any case, avoid exposing product to temperatures above the flash point.

Incompatible

Strong oxidizing agents, hard acids and bases.

Decomposition

Oxides of carbon, compounds of sulphur, phosphorus, nitrogen and hydrogen sulfide.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

TOXICITY

Eco-Toxicological Information: This product is not classified dangerous for the environment. List of Eco-Toxicological properties of the components |**COMPONENT**|**IDENT.**|**ECOTOX DATA**| |---|---|---| ||**NUMB.**|| |Zinc bis[O,O-bis(2-|CAS: 4259-|a) Aquatic acute toxicity : LC50 Fish Rainbow trout = 4.4 mg/L| |ethylhexyl)]|15-8 -|96h| |bis(dithiophosphate)|EINECS: 224-|| ||235-5|| |||b) Aquatic chronic toxicity : NOEC Fish Rainbow trout = 3.2| |||mg/L 96h| |||a) Aquatic acute toxicity : EC50 Daphnia = 75 mg/L 48h| |||b) Aquatic chronic toxicity : NOEC Daphnia = 32 mg/L 48h| |||a) Aquatic acute toxicity : EC50 Algae Green Algae = 410| |||mg/L 72h| b) Aquatic chronic toxicity : NOEC Algae Green Algae = 220 mg/L 72h No endocrine disruptor substances present in concentration >= 0.1%

This product is not classified dangerous for the environment.

PERSISTENCE AND DEGRADABILITY

Data on biodegradability of product are not available.

Data on biodegradability of product are not available.

BIOACCUMULATIVE POTENTIAL

Not available.

Not available.

MOBILITY IN SOIL

As the dispersion in the environment may result in contamination of environmental matrix (soil, subsoil, surface water and groundwater), do not release in the environment.

As the dispersion in the environment may result in contamination of environmental matrix (soil, subsoil, surface water and groundwater), do not release in the environment.

RESULTS OF PBT AND VPVB ASSESSMENT

vPvB substances: None - PBT substances: None

No PBT or vPvB substances are present.

ENDOCRINE DISRUPTING PROPERTIES

No endocrine disruptors present at concentrations >= 0.1%

No endocrine disruptors present at concentrations >= 0.1%

OTHER ADVERSE EFFECTS

No effect known.

No effect known.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Treatment

Prevent contamination of soil, drains and surface waters. Do not discharge in sewers, tunnels or water courses. Dispose in accordance with local or national regulations via authorised person/licensed waste disposal contractor.

Disposal

The used product has to be considered a special waste to be classified in accordance to Directive 2008/98/EC on waste and related legislation.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Regulation (EC) No 1272/2008, Regulation (EC) No 1907/2006, and related national/European legislations concerning classification, labelling, packaging, and worker safety.

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for DEVELON AXLE/TRANSMISSION 10W-30?

The signal word is no signal word.

What is the physical form of DEVELON AXLE/TRANSMISSION 10W-30?

DEVELON AXLE/TRANSMISSION 10W-30 is a liquid appearing as viscous amber with amber color. It has not relevant odor.

What is DEVELON AXLE/TRANSMISSION 10W-30 used for?

Lubricant for transmission system.

What is the melting point of DEVELON AXLE/TRANSMISSION 10W-30?

The melting point is N.A. and the boiling point is 300 °C (572 °F).

Compliance Scanner

Scan your compliance