NextSDS Logo
Safety Data Sheet EN

GRF T-88 BO 1L*8 NLFR

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
GRF T-88 BO 1L*8 NLFR

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Adhesive

Uses advised against

No further relevant information available.

Manufacturers & Suppliers

B

Bison International B.V.

manufacturer

Dr.A.F.Philipsstraat 9, NL-4462 EW Goes, PO Box 160, NL-4460 AD Goes

+31 88 3235700

Emergency Contacts

NHS (England and Wales)

111

NHS 24 (Scotland)

111

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Flam. Liq. Cat. 2 H225
Eye Irrit. Cat. 2 H319
STOT SE Cat. 3 H336

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

Hazard Statements

H225 Highly flammable liquid and vapour.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P261 Avoid breathing vapours.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P501 Dispose of contents/container in accordance with national regulations.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Adhesive

Chemical Name CAS Number Concentration Hazardous
Butanone EC: 201-159-0 78-93-3 50 - 100% Yes

For the wording of the listed hazard phrases refer to section 16.

Notes

For the wording of the listed hazard phrases refer to section 16.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Supply fresh air; consult doctor in case of complaints. No special measures required.

Eye contact

Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Ingestion

If symptoms persist consult doctor.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water haze, Alcohol resistant foam, Fire-extinguishing powder, Carbon dioxide

Unsuitable media

Water with full jet

Specific hazards

No further relevant information available.

Instructions

Cool endangered receptacles with water spray.

Firefighter Protection

No special measures required.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Wear protective equipment. Keep unprotected persons away.

Environmental

Do not allow to enter sewers/ surface or ground water.

Cleanup methods

Send for recovery or disposal in suitable receptacles. Absorb with liquid-binding material.

Materials: sand, diatomite, acid binders, universal binders, sawdust

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Ensure good interior ventilation, especially at floor level. (Fumes are heavier than air). Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols.

Storage

Store in a cool location. Keep container tightly sealed. Store in cool, dry conditions in well sealed receptacles.

Fire prevention

Keep ignition sources away - Do not smoke.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

No further data; see section 7.

Hands

Solvent resistant gloves. The glove material has to be impermeable and resistant to the product / the substance / the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: Butyl rubber, BR; Nitrile rubber, NBR. Recommended thickness of the material: > 0,12 mm; > 0,7 mm. Penetration time of glove material: For the mixture of chemicals mentioned below the penetration time has to be at least 10 minutes (Permeation according to EN 374 Part 3: Level 1). For the mixture of chemicals mentioned below the penetration time has to be at least 120 minutes (Permeation according to EN 374 Part 3: Level 4).

Eyes

Avoid contact with the eyes.

Respiratory

Use suitable respiratory protective device in case of insufficient ventilation. Recommended filter device for short term use: Filter A

Skin/Body

Immediately remove all soiled and contaminated clothing.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
Colourless
Colour Intensity
---
Form
Fluid
Odor
Like ketone
Odor Threshold
Not determined.
Ph
Not determined.
Melting Point
Undetermined.
Boiling Point
79-80.5 °C
Flash Point
-9 °C
Freezing Point
Undetermined.
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Not determined.
Vapor Pressure
105 hPa
Vapor Density
Not determined.
Relative Density
Not determined.
Bulk Density
---
Density
0.883 g/cm³
Flammability
Highly flammable.
Upper Explosive Limit
11.5 Vol %
Lower Explosive Limit
1.8 Vol %
Explosive Limits
---
Auto Ignition Temperature
514 °C
Decomposition Temperature
Not determined.
Solubility
Not miscible or difficult to mix.
Partition Coefficient
Not determined.
Solubility In Water
Not miscible or difficult to mix.
Solubility In Fat
---
Molecular Weight
---
Voc Content
80.40 %
Metal Corrosion
Void
Dynamic Viscosity
375 mPas
Kinematic Viscosity
Not determined.
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

No decomposition if used according to specifications.

Reactivity

No further relevant information available.

Hazardous reactions

No dangerous reactions known.

Avoid

No further relevant information available.

Incompatible

No further relevant information available.

Decomposition

Danger of forming toxic pyrolysis products.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Treatment

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations.

Disposal

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1133
Shipping Name
1133 ADHESIVES, special provision 640D ADHESIVES
Transport Class
3
Packing Group
II
ADR

Warning: Flammable liquids.

IMDG

Warning: Flammable liquids.

IATA

Warning: Flammable liquids.

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for GRF T-88 BO 1L*8 NLFR?

The signal word is danger.

What is the physical form of GRF T-88 BO 1L*8 NLFR?

GRF T-88 BO 1L*8 NLFR is a liquid with colourless color. It has like ketone odor.

What is the solubility of GRF T-88 BO 1L*8 NLFR?

Not miscible or difficult to mix.

What is GRF T-88 BO 1L*8 NLFR used for?

Adhesive

What are the hazard statements for GRF T-88 BO 1L*8 NLFR?

This substance has 3 hazard statements:

  • H225: Highly flammable liquid and vapour.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.

What is the melting point of GRF T-88 BO 1L*8 NLFR?

The melting point is Undetermined. and the boiling point is 79-80.5 °C.

Compliance Scanner

Scan your compliance