TPUC3

Move to fresh air. If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.

Immediate medical treatment is necessary as untreated wounds from corrosion of the skin heal slowly and with difficulty. If on skin, rinse well with water. If on clothes, remove clothes.

In the case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Continue rinsing eyes during transport to hospital. Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist.

Symptoms: Small amounts splashed into eyes can cause irreversible tissue damage and blindness.

Clean mouth with water and drink afterwards plenty of water. Keep respiratory tract clear. Do NOT induce vomiting. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician. Take victim immediately to hospital.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

High volume water jet

Do not allow run-off from fire fighting to enter drains or water courses.

Use personal protective equipment. Refer to protective measures listed in sections 7 and 8.

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so. Local authorities should be advised if significant spillages cannot be contained.

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Keep in suitable, closed containers for disposal.

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Do not breathe vapours/dust. Avoid exposure - obtain special instructions before use. Avoid contact with skin and eyes. For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area.

Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Electrical installations / working materials must comply with the technological safety standards.

When using do not eat or drink. When using do not smoke. Wash hands before breaks and at the end of workday.

Normal measures for preventive fire protection.

No data available

Material : In case of contact through splashing: Nitrile rubber, Break through time : > 30 min, Glove thickness : > 0,11 mm. In case of full contact: Material : butyl-rubber, Break through time : > 480 min, Glove thickness : > 0,4 mm. The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374.

Eye wash bottle with pure water, Tightly fitting safety goggles, face-shield and protective suit for abnormal processing problems. Use eye protection according to EN 166.

In the case of vapour formation use a respirator with an approved filter.

Impervious clothing. Choose body protection according to the amount and concentration of the dangerous substance at the work place.

Stable under normal conditions.

No dangerous reaction known under conditions of normal use.

Reacts with the following substances: Acids No decomposition if stored and applied as directed.

No data available

Acids

No data available

Send to a licensed waste management company. Can be disposed as waste water, when in compliance with local regulations.

The product should not be allowed to enter drains, water courses or the soil. Do not contaminate ponds, waterways or ditches with chemical or used container.