ELASTOSIL® E43 TRANSPARENT

If inhaled, remove to fresh air.

For skin contact, immediately wipe away excess material. Use a waterless hand cleaner to remove as much of the remaining material as possible. Wash with soap and water.

If contact with eyes, immediately hold eyelids apart and flush with plenty of water for at least 15 min.

If swallowed, do not induce vomiting. Induce drinking plenty of water in small portions. Get medical attention immediately. Show label.

water-spray, carbon dioxide, dry chemical or alcohol-resistant foam.

sharp water jet

Consider possible formation of explosive mixtures with air, for example in uncleaned containers.

Cool endangered containers with water.

Secure the area. Keep unprotected persons away. Avoid contact with eyes and skin. Do not inhale gases/vapours/aerosols. If material is released indicate risk of slipping. Do not walk through spilled material.

Scoop up large quantities after dusting surfaces with sand or Fuller's earth to prevent sticking.

Prevent material from entering surface waters, drains or sewers and soil.

Sweep or scrape up the spilled material and place in an appropriate chemical waste container. Clean any slippery coating that remains using a detergent / soap solution or another biodegradable cleaner. Apply sand or other inert granular material to improve traction.

Materials: sand, Fuller's earth, detergent / soap solution, biodegradable cleaner, inert granular material

Ensure adequate ventilation. Must be syphoned off in situ. Keep away from incompatible substances in accordance with section 10. Observe information in section 8.

Store in a dry and cool place. Protect against moisture. Store container in a well ventilated place.

Keep away from sources of ignition and do not smoke. Take precautionary measures against electrostatic charging. Cool endangered containers with water.

Use only with adequate ventilation. Local exhaust ventilation which meets the requirements of ANSI Z9.2 is recommended to control airborne contaminants at the point of use.

Protective gloves made of fluorinated rubber

Safety glasses with side shields or chemical safety goggles.

A NIOSH approved air purifying respirator equipped with universal multi-contaminant multi-gas/vapor cartridges is recommended if overexposure to chemical vapors could occur.

protective clothing to cover exposed areas of arms, legs and torso

If stored and handled in accordance with standard industrial practices no hazardous reactions are known.

Hazardous polymerization cannot occur.

Moisture, heat, open flames, and other sources of ignition.

water, basic substances and alcohols.

Acetic acid by hydrolysis. Measurements have shown the formation of small amounts of formaldehyde at temperatures above about 150 °C (302 °F) through oxidation.

landfill or incineration

Material that cannot be used, reprocessed or recycled should be disposed of in accordance with Federal, State, and local regulations at an approved facility.