INTERNATIONAL THINNER/EQPT CLEANER

If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately.

Symptoms: Harmful if inhaled. Causes nose and throat irritation. Vapors may affect the brain or nervous system causing dizziness, headache or nausea.

In case of contact, immediately flush skin with soap and plenty of water. Get medical attention immediately.

Symptoms: Causes skin irritation. May be harmful if absorbed through the skin.

In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately.

Symptoms: Causes severe eye irritation.

If swallowed, immediately contact Poison Control Center at 1-800-854-6813. DO NOT induce vomiting unless instructed to do so by medical personnel. Never give anything by mouth to an unconscious person.

Symptoms: Harmful if swallowed. May cause abdominal pain, nausea, vomiting, diarrhea, or drowsiness.

SMALL FIRES: Use dry chemical, CO2, water spray or alcohol-resistant foam. LARGE FIRES: Use water spray, fog, or alcohol-resistant foam.

Do not use straight streams.

FLAMMABLE/COMBUSTIBLE MATERIALS: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks) creating a vapor explosion hazard. Runoff to sewers may create fire or explosion hazard. Containers may explode when heated.

Move containers from fire area if you can do so without risk.

Do not touch or walk through spilled material. Stop leak if you can do so without risk. Stay upwind. Keep out of low areas.

Consider initial downwind evacuation for at least 300 meters (1000 feet).

Do not allow spills to enter drains or watercourses.

Absorb or cover with dry earth, sand, or other non-combustible material and transfer to containers.

Vapors may cause flash fire or ignite explosively. Avoid contact with eyes, skin and clothing. Do not smoke. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Wash thoroughly after handling. Close container after each use.

Store between 40-100F (4-38C). Keep away from heat, sparks and flame.

Wash thoroughly after handling.

Keep away from heat, sparks and flame. Do not smoke. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone.

Depending on the site-specific conditions of use, provide adequate ventilation.

Depending on the site-specific conditions of use, protective gloves may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use.

Avoid contact with eyes. Depending on the site-specific conditions of use, safety glasses, chemical goggles, and/or head and face protection may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use.

Select equipment to provide protection from the ingredients listed in Section 3 of this document. Ensure fresh air entry during application and drying. If you experience eye watering, headache or dizziness or if air monitoring demonstrates dust, vapor, or mist levels are above applicable limits, wear an appropriate, properly fitted respirator (NIOSH approved) during and after application. Follow respirator manufacturer's directions for respirator use.

Protective equipment should be selected to provide protection from exposure to the chemicals listed in Section 3 of this document. Depending on the site-specific conditions of use, protective gloves, apron, boots, head and face protection may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use.

This product is stable and hazardous polymerization will not occur. Not sensitive to mechanical impact. Excessive heat and fumes generation can occur if improperly handled.

No data available

No data available

No data available

Strong oxidizing agents.

FLAMMABLE/COMBUSTIBLE MATERIALS: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks) creating a vapor explosion hazard. Runoff to sewers may create fire or explosion hazard. Containers may explode when heated.

Do not allow spills to enter drains or watercourses.

Dispose of in accordance with local, state and federal regulations.

Not Applicable