MIRAMER M1182

Remove person to fresh air and keep comfortable for breathing. If breathing is difficult, give oxygen. Obtain medical assistance. Remove all contaminated clothing and footwear.

Wash skin with plenty of water. Take off contaminated clothing. Wash clothing before re-using. If skin irritation or rash occurs: Get medical advice/attention.

Symptoms: May cause an allergic skin reaction.

Rinse cautiously with water for several minutes. Rinse immediately and thoroughly, pulling the eyelids well away from the eye (15 minutes minimum). Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Obtain medical attention if pain, blinking or redness persists.

Symptoms: May cause severe irritation.

Immediately call a POISON CENTER/doctor. Never attempt to induce vomiting. Do not give an unconscious person anything to drink.

Water spray. Dry powder. Carbon dioxide.

Do not use a heavy water stream.

Heating may cause an explosion. Hazardous vapours may be released.

Get the package away from the fire if this can be done without risk. Cool containers / tanks with spray water if possible.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Stop leak if safe to do so. Do not attempt to take action without suitable protective equipment.

Avoid release to the environment.

Contain or absorb spilled liquid with non-combustible material.

Materials: non-combustible material

To facilitate product transfer from original container, product may be heated to 40°C. Keep away from heat/hot surfaces/sparks/open flames/other ignition sources. No smoking. Handle and open container with care. Ground/bond container and receiving equipment. Ensure good ventilation of the work station. Avoid contact with skin and eyes. Avoid breathing vapours, spray. Wear personal protective equipment.

Protect from sunlight. Store in a closed container. Store in dry, cool, well-ventilated area.

Contaminated work clothing should not be allowed out of the workplace. Wash contaminated clothing before reuse. Do not eat, drink or smoke when using this product. Always wash hands after handling the product.

Ensure good ventilation of the work station. Both local exhaust and general room ventilation are usually required.

Wear protective gloves. Wear Chemical resistant gloves (according to European standard NF ISO 374-1 or equivalent). Choosing the proper glove is a decision that depends not only on the type of material, but also on other quality features, which differ for each manufacturer. (recommended) Nitrile-rubber protective gloves: Thickness >0.56mm

Eye protection, including both chemical splash goggles and face shield, must be worn when possibility exists for eye contact due to spraying liquid or airborne particles. Safety glasses. Splash goggles. Protective goggles or face shield

In case of insufficient ventilation, wear suitable respiratory equipment. Approved organic vapour respirator. Type A - High-boiling (>65 °C) organic compounds

If skin contact or contamination of clothing is possible, protective clothing should be worn

Avoid release to the environment.

Stable under normal conditions.

The product is non-reactive under normal conditions of use, storage and transport.

Heating may cause an explosion. Hazardous polymerization may occur if exposed to high temperature.

Keep away from heat/hot surfaces/sparks/open flames/other ignition sources. No smoking. Protect from the exposure to the light.

Initiators. Strong alkalis. Peroxides. Curing agent. Reactive metals (Al, K, Zn ...).

In the event of thermal decomposition : Carbon oxides (CO, CO2). Soot. Smokes.

Dispose of contents/container to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulation.

Dispose of contents/container to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulation.