MARLIPAL 24/939

Remove from exposure, lie down. If breathing is irregular or stopped, administer artificial respiration. Monitor breathing, give oxygen if necessary. Consult a physician.

Wash off immediately with plenty of water. Consult a physician if necessary.

Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.

Symptoms: Causes serious eye damage.

Consult a physician. Do not induce vomiting without medical advice. Never give anything by mouth to an unconscious person.

Water spray, Dry powder, Foam, Carbon dioxide (CO2)

High volume water jet

Dangerous gases or fumes may occur in case of fire.

Standard procedure for chemical fires.

Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system.

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust).

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Wear personal protective equipment. Avoid contact with skin and eyes.

Keep tightly closed in a dry and cool place. Stable at normal ambient temperature and pressure.

Normal measures for preventive fire protection. Do not spray on a naked flame or any incandescent material.

Material: butyl-rubber, Break through time: >= 480 min, Glove thickness: >= 0.7 mm. Material: Nitrile rubber, Break through time: >= 30 min, Glove thickness: >= 0.4 mm. The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature).

Safety glasses with side-shields. Wear suitable eye/face protection.

No personal respiratory protective equipment normally required. In inadequately ventilated areas, where workplace limits are exceeded, where unpleasant odours exist or where aerosols are in use, or smoke and mist occur, use self-contained breathing apparatus or breathing apparatus with a type A filter or appropriate combined filter (e.g. where aerosols are in use, or smoke and mist occur, A-P2 or ABEK-P2), in compliance with EN 141.

Wear suitable protective equipment. Avoid contact with the skin.

Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system.

No decomposition if stored and applied as directed.

Stable at normal ambient temperature and pressure.

None known.

Direct heating, dirt, chemical contamination, sunlight, UV or ionising radiation.

Strong acids and oxidizing agents;

No decomposition if stored and applied as directed. Hazardous decomposition products formed under fire conditions.