DAPHNE SUPER HYDRO 46HN

Remove person to fresh air and keep comfortable for breathing. Get medical attention if symptoms occur.

Wash skin with plenty of water. Get medical attention if irritation develops and persists.

Rinse immediately and thoroughly, pulling the eyelids well away from the eye (15 minutes minimum). Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists.

Do NOT induce vomiting. Call a poison center or a doctor if you feel unwell.

Dry powder. Foam. Carbon dioxide. Alcohol resistant foam.

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed.

Use standard firefighting procedures and consider the hazards of other involved materials.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Ensure adequate ventilation. Stop leak without risks if possible. Move containers from fire area if it can be done without personal risk.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Avoid discharge into drains, water courses or onto the ground. Prevent further leakage or spillage if safe to do so. Inform appropriate managerial or supervisory personnel of all environmental releases.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth, absorbent material (e.g. cloth, fleece)

Wear personal protective equipment. Ensure good ventilation of the work station.

Store in a well-ventilated place. Keep cool.

Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Observe good industrial hygiene practices.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level

Protective gloves. Material: Nitrile rubber (NBR), Permeation: 2 (> 30 minutes), Thickness: > 0.3 mm, Standard: EN ISO 374. The recommendation is only valid for the supplied product and the stated application. Special working conditions, like heat or mechanical strain, which deviate from the test conditions, can reduce the protective effect provided by the recommended glove

Safety glasses with side shields. EN 166.

In case of insufficient ventilation, wear suitable respiratory equipment. Filter type: A-P2

Wear suitable protective clothing

Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all environmental releases.

Stable under normal conditions.

The product is non-reactive under normal conditions of use, storage and transport.

No dangerous reactions known under normal conditions of use.

No flames, no sparks. Eliminate all sources of ignition.

Bases. Strong oxidizing agent.

Irritating and/or toxic fumes and gases may be emitted upon the products decomposition.

Do not allow this material to drain into sewers/water supplies. Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Do not contaminate ponds, waterways or ditches with chemical or used container. Dispose of contents/container in accordance with licensed collector's sorting instructions.

Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken to an approved waste handling site for recycling or disposal.