DAPHNE HERMETIC OIL PS-F

Remove person to fresh air and keep comfortable for breathing. Get medical attention if symptoms occur.

Wash with plenty of water/... Take off contaminated clothing and wash it before reuse. If skin irritation or rash occurs: Get medical advice/attention.

Symptoms: skin irritation or rash

Rinse immediately with plenty of water. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Symptoms: eye irritation

Get medical attention if symptoms occur. Rinse mouth thoroughly.

Water spray. Dry powder. Foam. Carbon dioxide.

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed.

Move containers from fire area if it can be done without personal risk.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Local authorities should be advised if significant spillages cannot be contained.

Take up liquid spill into absorbent material. Clean surface thoroughly to remove residual contamination. Never return spills in original containers for re-use.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Take up liquid spill into absorbent material. Clean surface thoroughly to remove residual contamination.

Materials: absorbent material, vermiculite, dry sand or earth

Ensure good ventilation of the work station. Avoid contact with skin and eyes. Avoid breathing mist, vapours. Wear personal protective equipment. Protect material from direct sunlight. Observe good industrial hygiene practices.

Store in original tightly closed container.

Do not eat, drink or smoke when using this product. Always wash hands after handling the product.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

Protective gloves.

Safety glasses with side shields

In case of insufficient ventilation, wear suitable respiratory equipment.

Wear suitable protective clothing.

Inform appropriate managerial or supervisory personnel of all environmental releases.

Stable under normal conditions.

The product is non-reactive under normal conditions of use, storage and transport.

No dangerous reactions known under normal conditions of use.

Contact with incompatible materials.

Strong oxidizing agents.

Under normal conditions of storage and use, hazardous decomposition products should not be produced.

Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Do not allow this material to drain into sewers/water supplies. Do not contaminate ponds, waterways or ditches with chemical or used container. Dispose of contents/container in accordance with licensed collector's sorting instructions.

Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken for recycling, recovery or waste in accordance with local regulation.