AVENO FS Low SAPS Extra 5W-30

Provide fresh air. Consult a doctor immediately.

Consult a doctor immediately.

In case of contact with eyes flush immediately with plenty of flowing water for 10 to 15 minutes holding eyelids apart and consult an ophthalmologist.

Rinse mouth thoroughly with water. Consult a doctor immediately. Rinse mouth. Get medical advice/ attention if you feel unwell. Let 1 glass of water be drunken in little sips (dilution effect).

Use water spray jet to protect personnel and to cool endangered containers. Water spray jet alcohol resistant foam Extinguishing powder Carbon dioxide (CO2)

Full water jet

During heating or in case of fire, toxic gases is possible. The formation of combustible vapours is possible at temperatures above: Flash point Combustible

Move undamaged containers from immediate hazard area if it can be done safely.

Remove persons to safety.

Do not allow to enter into soil/subsoil. Do not allow to enter into surface water or drains. Prevent spread over a wide area (e.g. by containment or oil barriers).

Absorb with liquid-binding material (sand, diatomaceous earth, acid- or universal binding agents). Remove from the water surface (e.g. skimming, sucking).

Materials: Sand, Kieselguhr, Universal binder, Chemical binding agents, containing acids, liquid-binding material (sand, diatomaceous earth, acid- or universal binding agents).

When using do not eat, drink, smoke, sniff. Wash hands before breaks and after work. Do not put any product-impregnated cleaning rags into your trouser pockets. Clear spills immediately. Use appropriate container to avoid environmental contamination. Wear personal protection equipment (refer to section 8).

Keep container tightly closed in a cool, well-ventilated place. Store in a cool dry place. Keep away from heat.

Minimum standard for preventive measures while handling with working materials are specified in the TRGS 500. When using do not eat, drink, smoke, sniff. Avoid contact with skin, eyes and clothes.

No special fire protection measures are necessary. Take precautionary measures against static discharge. Keep away from sources of ignition - No smoking.

See section 7. No additional measures necessary.

Suitable material: NBR (Nitrile rubber), PVC (polyvinyl chloride), CR (polychloroprene, chloroprene rubber) Thickness of the glove material: ≥ 0,4 mm Breakthrough time: 480 min. The quality of the protective gloves resistant to chemicals must be chosen as a function of the specific working place concentration and quantity of hazardous substances. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves. Tested protective gloves must be worn: EN ISO 374

During transfer: Eye glasses with side protection Wear eye/face protection. EN 166

Usually no personal respirative protection necessary.

Suitable protective clothing: Protective clothing in the case of wanting to use the gloves again, clean them before taking off and air them well. Breakthrough times and swelling properties of the material must be taken into consideration.

See section 7. No additional measures necessary.

The mixture is chemically stable under recommended conditions of storage, use and temperature.

No known hazardous reactions. Combustible

No hazardous reaction when handled and stored according to provisions.

To avoid thermal decomposition do not overheat.

Acid, Oxidising agent, Reducing agent

Carbon dioxide, Carbon monoxide, Nitrogen oxides (NOx) Gases/ vapours, toxic

Dispose of waste according to applicable legislation.

Dispose of waste according to applicable legislation. Consult the appropriate local waste disposal expert about waste disposal.